Lawn Mower Starters
Find your part
Enter your model number or a part number and click "Search"Popular Lawn Mower Starters
Your Price
$3.94
Starter Pawl-Ratchet
PartSelect Number PS8942598
Manufacturer Part Number 281505S
The manufacturer-approved Ratchet Pawl (Starter Pawl) comes in a set of two (2). This part attaches inside the recoil assembly, and is used to engage the flywheel. if broken due to wear/damage it will have a hard time engaging the fly wheel, making the engine harder to start, and should be replaced. Installation is rated as "Easy" by customers, and will require a screwdriver, pliers and nutdriver. Refer to your make, model and diagram to ensure this is the correct part for you.This model is plastic and comes in white.
Your Price
$14.83
Spring-Rewind Str
PartSelect Number PS8978476
Manufacturer Part Number 490179
This rewind starter spring or as it is also known, recoil spring, rewinds the pull robe back into the starter housing of your engine. The spring is made of metal, silver colored, and sold individually.
Over time, you may notice that you are having trouble retracting your pull cord, which could be a symptom of the rewind starter spring failing due to fatigue or wear. Replacing this part is a repair our customers found easy.
Locate and replace the start spring inside the starter housing; no special tools are required for this job.
Your Price
$20.82
Your Price
$7.65
Gear-Pinion (Plastic and Aluminum Ring Gear)
PartSelect Number PS9066374
Manufacturer Part Number 695708
Your Price
$18.30
Your Price
$35.30
Your Price
$35.90
Solenoid-Starter
PartSelect Number PS9064363
Manufacturer Part Number 691656
Installation Instructions
Bruce from CARNATION, WA
Wouldn’t start.
I installed a new solenoid starter. Took me a total of 20 minutes. Started right up.
Read more...
Your Price
$119.70
Starter-Rewind
PartSelect Number PS8981884
Manufacturer Part Number 497680
This recoil starter is for lawn and garden equipment engines.
Recoil starter spins the crankshaft to start the engine when you pull the rope.
Installation Instructions
Seikai from MARICOPA, CA
starter rewind cord broke
I found the model number of the Briggs & Stratton engine on the inside of the engine housing. Ordered a new starter-rewind unit, as the old cord broke and the thing was well worn. The instructions were clear enough, but to get the old starter off I had to drill out four rivets, which just spin around when you try. I used a hacksaw, chisel, pliers, whatever worked on each rivet; this took a while. When they were finally removed, the new starter pull unit was relatively easy to install with the small nuts and bolts provided. On the Yard Machines log splitter, putting back the engine housing is quite tricky; you have to jostle the thing into place, get the pull handle above the cover and line up the bolt holes.
Read more...
Your Price
$5.38
