Jet Band Saw Parts

This deep-groove ball bearing is a durable replacement component designed to support smooth, high-speed rotation in power-driven equipment. Featuring a double metal-shielded design, it helps keep contaminants out while retaining internal lubrication for quieter operation and extended service life. Manufactured from hardened steel and pre-lubricated for immediate use, the bearing is built to handle continuous motion and demanding operating conditions. It is commonly replaced when excessive noise, vibration, or reduced efficiency indicates bearing wear, helping restore reliable, low-friction performance in moving assemblies.

Genuine Manufacturer Sourced replacement part used on a variety of Power Tools. This part is made out of Metal and it is sold individually. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is an authentic replacement wheel tire for Wilton and Jet band saws. It is supplied directly from original equipment manufacturer and it is sold individually. Its purpose is to provide a stable grip for the saw blade. When attaching the new tire on a band saw wheel, it may appear too be too small, however it really is not. These tires when new are typically approximately two (2) or more inches shorter than the old tire. Tires are supposed to fit very tightly against the bad saw wheel. As the tire ages, the rubber hardens allowing for the blade to slip. Note, it is a good idea to put the new tire in hot/warm water to heat it up just enough to make it pliable enough to stretch. Its advised to have two people in the stretching process.

This pad is an OEM part direct from Powermatic. Constructed of soft material, this item is compatible with several band saw devices. The pad is fitted onto the fence, providing protection from abrasion. The pad is sold individually. No tools are required for the replacement.

This is an authentic OEM replacement part used for various handheld power tools including models by Powermatic, Jet, and Wilton. Bearings stabilize and buffer moving parts to facilitate rotation of such parts as shafts, axles, and gears. They are commonly replaced due to this high wear function. This part sold individually.

This is a genuine Powermatic and Jet part sourced directly from the manufacturer for use in planers, saws, and jointers. The ball bearing fits between the gear and the oil seal. A screwdriver may be necessary during the installation of this item. It may become broken or wear down and will need to be replaced. This is available as an individual replacement part and is made of metal.

This item is a genuine part that has been sourced from the original manufacturer to be used with verticle bandsaws from Wilton and Jet. The durable plastic insert fits into the cap in the table where the blade passes through the table. The insert is used to reduce the gap around the blade in order to better support the material as it is being cut. Inserts wear down from normal use, and will eventually need to be replaced to maintain clean accurate cuts. This part is priced as a single item, please note tools may not be necessary to install the insert.

This part is an OEM from the Wilton manufacturer. The carbine blade guard is compatible with many band saw devices. The plastic item is fitted on each side of the saw head's support bracket, keeping the blade straight for cutting projects. A pair of pliers and a screwdriver may be helpful for making the repair. The carbine blade guard is sold individually.

This replacement part is supplied by the original equipment manufacturer for use with Powermatic and Jet power equipment. Ball bearings are generally used to reduce friction between rotating parts, please make sure to check appropriate diagram of your model for the correct location and use of this hardware. Over time the rollers may begin to wear out restricting the movement and eventually requiring a replacement to maintain peak performance. This high-quality part is made of durable metal and it is sold individually.

The lock plate goes between the lock handle and the pad. This is an original Powermatic and Jet part for use in bandsaws. It may require a screwdriver during installation. The plate may become broken and will need to be replaced. This item is made of metal and sold individually.