Freezer Filters

Your Price

$30.67

Air Filter

★★★★★

16 Reviews

PartSelect Number PS1993820

Manufacturer Part Number EAFCBF

This manufacturer-approved air filter system for refrigerators eliminates odors and any impurities. It does this by neutralizing and removing odor-causing molecules. For best results, it is important to change the filter every 6 months to ensure that food is kept fresh, and the humidity is controlled. This part measures about 7 inches wide and 5 inches deep. Follow installation instructions provided by the manufacturer when installing this part to ensure accurate results and further guidance. Remember to unplug the refrigerator from the power source before starting this project. The air filter may be located in different places depending on your appliance, but is usually on the inner right or left side. See your manual for exact location. Our customers rated this as a very easy repair that takes only a few minutes; just locate and remove the old air filter and insert the new one to complete the repair, which requires no tools.

Fixes these symptoms

Fridge too cold
Fridge too warm
Ice maker not making ice
See more...

Installation Instructions

melvin from BASKING RIDGE, NJ

you r label (this end in arrow is wrong

placed filter in sideways Read more...

Your Price

$62.55

Refrigerator Ice and Water Filter

★★★★★

74 Reviews

PartSelect Number PS8746144

Manufacturer Part Number MWFP

This OEM ice and water filter fits side-by-side and bottom-freezer GE models. The most common reason you would need to change this part is if you have never updated your model and it is no longer filtering your water. This also may lead to your refrigerator not dispensing water or ice properly. Manufacturers recommend you change your filter every six months to ensure it properly filters impurities. Depending on the model, a red light might also indicate that the filter is due for a replacement. Note: As per the manufacturer, this is an updated water filter. If you have never installed the updated part or your old model was made by Culligan, you may need the adapter to install the filter. See related parts. This filter is sold individually This filter is located inside the refrigerators upper right corner. It is common for water to drip from the dispenser when being changed so place a cloth underneath before you begin this repair. To remove the filter, turn it to the left until it releases without pulling down. Fill the new filter with tap water to prepare it. Position the new filter into the holder taking note of the arrows. The arrow on the front should be facing out. Gently push up on the filter and turn it to the right to secure it. Do not over-tighten. To release air in the system run 1-1/2 gallons of water through it. If your model has a reset button, press and hold this for a few seconds to reset it.

Fixes these symptoms

Fridge too warm
Ice maker dispenses too little ice
Ice maker not making ice
See more...

Installation Instructions

Fred from River Ridge, LA

Ice Maker stopped dispensing ice through Ice Maker Dispensor.

After taking Ice Maker's ice collection container out, I noticed that the plastic cup drive was broken. I did a websearch for repair and replacement parts for our GE refrigerator. I found PartSelect website easy to navigate and find the replacement part necessary...and placed an order.

Once I received the shipment, I placed the Cup Drive into position and used the flat edge of a knife to allow the Cup Drive to slide into the tight-fitting position necessary. After positioning into place, I placed the ice collection bin back into the freezer...turned the ice-maker back on...and waited for ice to be made. A day later, the ice maker had produced enough ice to test the ice maker's dispensing mechinism. The cup drive worked perfectly...and ice began to be dispensed. The dispensor has been working ever since.

I also replace the ice and water filter...another very easy task...of unscrewing the old and replacing with the new filter. After replacing the filter, I let the water dispensor run for 2 minutes to flush all air out the system. The water dispensor work perfectly. Read more...

Your Price

$74.66

Water Filter

★★★★★

35 Reviews

PartSelect Number PS11722126

Manufacturer Part Number EDR2RXD1

EveryDrop Filter 2 is the only filter Certified by Whirlpool Corporation to work with your Whirlpool, Maytag, KitchenAid, JennAir, and Amana refrigerator. It is NSF Certified to reduce 24 contaminants, including pharmaceuticals, waterborne parasites, lead, and pesticides. The only Genuine Replacement for the discontinued W10413645A used in bottom freezer refrigerators, which accept Filter 2. It measures 2 inches deep, 2 inches wide and 7-1/2 inches high. The filter compartment is in the top right corner. To install, pop out the old filter and have a cloth ready to wipe up any water. Reattach the bottom cap to the new one and slide it in. When it is locked in place you will hear a click. Be careful not to over-tighten. Run water thoroughly to ensure the filter is ready for use. Replace filter every 6 months or 200 gallons to maximize contaminant reduction.

Fixes these symptoms

Ice maker not making ice
See more...

Installation Instructions

Wyn from SURPRISE, AZ

Quit making ice

A repair man came out and had to replace the ice maker Read more...

Your Price

$30.01

Air Filter

★★★★★

2 Reviews

PartSelect Number PS1150700

Manufacturer Part Number EAF1CB

This part is the replacement air filter for your refrigerator. It is black in color and is cylindrical in shape. It is approximately 5 inches long, and 2.5 inches in diameter. The air filter prevents debris and other particles from entering your refrigerator and ultimately contaminating your food. If the air filter is damaged, these particles can get in. The air filter also absorbs many refrigerator odors. It is recommended that you change the air filter about once every 6 months. This is an OEM part from the manufacturer and is sold individually.

Fixes these symptoms

Noisy
See more...

Installation Instructions

Bogdan from Lehi, UT

Bottom Door Bin had cracked

Not much of a repair. Just swapped the old bin with the new one. Read more...

Your Price

$13.48

Screen

★★★★★

1 Review

PartSelect Number PS11746894

Manufacturer Part Number WP96160

Found on the water inlet valve.

Installation Instructions

Peter from Aurora, IL

The fill cycles would start then stop suddenly

This was an easy repair.
1st I removed both water hoses
2nd I removed 1 hex head screw that released a backing plate & removed the plate holding the water inlet valve.
3rd I pulled the 4 electrical connections & loosened a clamp to remove a small water hose.
4th I removed 2 hex head screws that held the water valve to the backing plate.
-----------that was a whole 5 - 10 minutes!------------
Next I reversed the process
4th I attached the inlet valve with the 2 hex head screws
5th re-attached the 4 electrical connections(had slip on spades) pushed on the hose & tighterned the clamp.
6th replaced the backing plate with the inlet valve attached & tightened the single hex head screw.
7th re-attached the hot & cold lines................................DONE
15 minutes tops Read more...