Flex Parts

Genuine Manufacturer Sourced replacement part designed for use with certain Flex Power Tools. This part is made out of Carbon with a Lead Wire attached. This item includes One (1) Carbon Brush per order. Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

This replacement brush is a genuine OEM sourced item, not an aftermarket imitation. It is specially designed for Flex power tools. This item consists of (1) carbon brush with a lead wire attached. Please note, the brush holder and other parts are sold separately. It is recommended to replace both carbon brushes at the same time. You will need a screwdriver to complete this repair job.

Genuine OEM replacement part used on a variety of Circular Saws. This part is made out of Metal and it is Sold Individually. This pin fits in the Foot Assembly as part of Bevel Adjustment Assembly and locks with a Flange Nut which is Sold Separately.

Genuine OEM replacement part, this item is sold individually. The purpose of this Shoulder Bolt is to secure the Handle to the motor housing of the Saws shown below. There are four of these Bolts used, 2 on top of the handle and 2 at the bottom of the handle.

This part is an OEM from the Skil manufacturer. The metal washer is compatible with many circular saw devices. The washer is fitted between the retaining snap ring and blade bolt, securing the lower blade guard. This item distributes even pressure over the surface and provides a solid grip. The washer is sold individually. A screwdriver and a wrench are often needed to make the proper removal and replacement. A hex key and a wrench are necessary in this repair.

This is an authentic replacement part sourced directly from the manufacturer. The extension spring is found in worm drive skilsaws from Skil. This part is made of metal, and is used to apply tension to the lower guard, holding it in place when the blade is not in use. This item is sold individually.

This is an authentic replacement part manufactured for use with Flex polishers and angle grinders. The strain relief is used to protect the power cord where it enters the housing of the tool. This strain relief is sold as an individual replacement part.

This is an authentic replacement part for use with Skil worm drive saws. This metal lock lever is use to fasten the foot when adjusting the depth of cut. This lock lever is sold individually, please note additional parts are available separately.