Echo Edger Bearings

This single-row, deep-groove ball bearing is sized at 12x32x10mm and is made of durable metal. It is used to reduce friction and vibrations when it is in between two parts that are rotating or moving against each other. This bearing can handle forces that are applied to it up-and-down and sideways, also known as radial and axial loads. It is easy to install and can handle high rotational speeds without causing too much vibration or making much noise. Over time, this ball bearing wears out from heat and pressure and starts to fail. If the engine of your machine has been run without oil in the gas tank, this ball bearing can seize. In these situations, you will need to replace the ball bearings. Otherwise, you will notice that your machine overheats, works harder because of the increased friction it is handling, and produces excessive vibration and noise. To extract a ball bearing from your machine, you will need to insert a flat-head screwdriver through the bearing opening and against the seal. Then, tap the seal out with a mallet. Afterwards, slot a socket through the diameter of the bearing, and tap the entire bearing out of its place by again using a mallet. This authentic OEM part is sold individually, so be sure to refer to your user manual to verify how many bearings your machine needs and where they are in it.

This silver metal Ball Bearing is manufacturer certified, and used to reduce the friction between parts, and comes individually sold. If broken or worn down, you will hear a grinding, growling, stretching, or rumbling sound, and the part should be replaced. Installing this new part requires a bearing puller. Refer to your make, model and diagram to check if this is the right part.

This authentic replacement ball bearing is supplied by the original equipment manufacturer for use with Shindaiwa and Echo handheld tools. Ball bearings are used to reduce friction between rotating parts, over time due to heat, pressure and vibration the components may wear out and begin to fail eventually requiring a replacement. For correct location and use of the part, make sure to check appropriate diagrams of your model. This high-quality bearing allows is made of durable metal and it is sold individually.

This genuine manufacturer-sourced replacement part is specially designed for Shindaiwa and Echo lawn and garden equipment. Ball bearings are generally utilized to reduce the friction between rotating parts. The rollers help to distribute the weight while the minimal contact area of the ball reduces friction. To ensure the proper repair procedure, refer to the appropriate diagrams for your specific model. Note, this high-quality product is made of durable metal and is sold individually. A screwdriver, a wrench set, and pliers might be needed to take apart and reassemble the equipment when replacing this ball bearing.

This is an authentic Echo replacement part, sourced from the original manufacturer for use with outdoor power equipment. The metal ball bearing is commonly used to reduce friction between a rotating shaft and a fixed part assembly. This item is available as an individual replacement part.