Craftsman Table Saw Parts

This Genuine OEM carbon brush is an essential replacement part designed for use with a variety of DeWALT and Black & Decker saws. Sold individually, this high-quality component is made to conduct electrical current within the motor, enabling efficient power transfer and tool performance. Over time, carbon brushes naturally wear down due to friction and electrical contact, which can lead to intermittent motor issues or failure to start. Measuring 3/4 inch in length, 1/2 inch in width, and 1/4 inch in thickness, this brush is built to original specifications for a precise fit. When replacing carbon brushes, it’s important to also inspect the motor’s armature for signs of burns, cracks, or other damage, which may indicate a more serious issue. A hex key or screwdriver may be required for installation, depending on your tool model.

This is a Genuine Manufacturer Sourced replacement part. This is a Carbon Brush with Lead Wire attached and a Spring. This Brush is Sold Individually. Please note Brush Holder is Sold Separately. Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. It is recommended to replace both brushes at the same time. You would need a Screwdriver and Pliers to complete this job.

This is a genuine Ryobi Replacement part and is sold individually. Switches are commonly replaced parts in power tools. This is because switches use mechanical internals, causing them to degrade and wear out over time. A switch handles the on/off and variable speed functions. They also have a role in electric breaking; they can momentarily reverse electrical polarity. Some common signs of a broken or failing switch are: • The tool has completely stopped functioning • it will not turn on. • The tool operates intermittently, requiring multiple tries to turn on, until eventually it won't turn on at all.

The block connects to the work plate with hex nuts. This is an authentic Ryobi part sourced directly from the manufacturer for use in table saws. Keep in mind this high-quality part is sold individually. It is made out of metal and will require replacing if it becomes broken. A screwdriver, a set of pliers, and a wrench set may be needed during the installation of this part.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Ryobi table saws. This is an identical replacement for a missing or worn elevating shaft that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your unit for the correct location and application of this component. Keep in mind this high-quality item is made of durable metal and is sold individually.

Extension Wand (Sold Individually)

This is an authentic replacement part manufactured for use with Ryobi table saws. The shaft connects to the handwheel and is used to raise and lower the height of the blade. This elevating shaft is sold as an individual replacement part, please see model diagram for associative parts.

This replacement bearing is an authentic component which is supplied directly from the original equipment manufacturer for use with Ryobi table saws. Bearings are used to reduce friction between rotating parts, please make sure to check appropriate diagrams of your unit for the correct location and use of this hardware. Over time bearings tend to wear out and may begin to fail eventually requiring replacement to maintain peak performance. This part is made of high-quality metal and it is sold individually.

This durable plastic brush holder is an authentic OEM sourced item that is sold individually. It is a high quality item that is specially designed for Ryobi table saws. The purpose of this holder is to secure carbon brush in an electric power tool.

The throttle valve plug fits next to the o-ring and the throttle spring and helps to cover the throttle valve. It is available as an individual replacement part and is made of plastic. This genuine item is supplied by the original equipment manufacturer for use with Chicago Pneumatic ratchets. A set of pliers and a screwdriver may be required to replace this plug if it becomes broken.