Chicago Pneumatic Sander Parts

This o-ring is an authentic manufacturer sourced replacement part, it is not an aftermarket imitation. It is specially made for Chicago Pneumatic air hammers and sanders. It helps to provide an air tight seal between connected parts. Please make sure to check appropriate diagrams for correct location and use of this item. It is made from durable rubber and it is sold individually.

This is a set authentic replacement rotor blades commonly used on Chicago Pneumatic power tools. Supplied from original equipment manufacturer. These blades are attached to the rotor and they will push the air inside the power tool. This set includes four (4) compound material blades per order. Replacing these blades is an easy job and will require a set of wrenches and pliers.

This is a genuine item that is supplied directly from the original equipment manufacturer for Chicago Pneumatic sanders. It is an identical replacement for a missing or a faulty cover-motor housing that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality housing is made of durable plastic and is sold individually.

It is an identical replacement for the hardware that was installed on a new equipment. Check the diagrams for your specific model to ensure the correct replacement procedure. This high-quality nylon nut is made of durable metal and is sold as an individual item. It is supplied by the original manufacturer for Chicago Pneumatic tools. Note, a wrench will be needed to secure or remove it.

This is a genuine Chicago Pneumatic replacement part. This metal lever is used to open, and close the throttle valve to power on/off the pneumatic tool. The lever pivots on a roll pin which is available separately, the throttle lever is sold individually.

This is an authentic replacement part manufactured for use with Chicago Pneumatic sanders. The sanding pad is commonly used to mount the sanding discs. Sanding pads can wear out over time and replacing a worn pad will provide a more stable sanding surface. This sanding pad is available as an individual replacement part.

This is an authentic manufacturer sourced replacement part designed for use with Chicago Pneumatic impact wrenches. It helps to provide an air tight seal between a regulator and an air inlet bushing. This o-ring is made out of rubber material and it is sold individually. To complete this repair you will need a hex key/allen wrench.

This is an authentic Chicago Pneumatic replacement part manufactured for use with die grinders. The key fits into the slot on the spindle and into the keyway on the bevel gear to rotate the gear with the rotation of the spindle. This key is sold as an individual replacement part, please see model diagram for associative parts.