Chicago Pneumatic Parts

This is an authentic replacement part that is supplied directly from original equipment manufacturer for use with Chicago Pneumatic nailers. It is one of the o-rings for the throttle valve. Over time seals and o-rings tend to wear out and deteriorate eventually requiring replacement. Please note this durable high quality rubber o-ring is sold individually.

This o-ring is an authentic manufacturer sourced replacement part, it is not an aftermarket imitation. It is specially made for Chicago Pneumatic air hammers and sanders. It helps to provide an air tight seal between connected parts. Please make sure to check appropriate diagrams for correct location and use of this item. It is made from durable rubber and it is sold individually.

Genuine Chicago Pneumatic replacement part, this item is sold individually. This part acts as as a seal so that air will not leak out of the throttle assembly on the tools shown below. Over time it will become brittle and crack. It is a good Idea to keep an extra one on hand.

This is a set authentic replacement rotor blades commonly used on Chicago Pneumatic power tools. Supplied from original equipment manufacturer. These blades are attached to the rotor and they will push the air inside the power tool. This set includes four (4) compound material blades per order. Replacing these blades is an easy job and will require a set of wrenches and pliers.

The piston fits between the valve case and the cylinder. This is an OEM Chicago Pneumatic part directly sourced from the manufacturer for use in air hammers. This item is sold individually and is made out of metal. You may need a set of pliers when replacing this part. It will need to be replaced if it becomes broken.

This item is sold individually and is made of metal. The throttle valve spring fits between the air inlet bushing and the o-ring. It may require a wrench during installation and will need to be replaced if it becomes bent or broken. This is an authentic part from Chicago Pneumatic for use in air hammers.

This is a manufacturer sourced replacement part designed for use with Chicago Pneumatic ratchet/wrenchs. This o-ring provides an air-tight seal for the valve. Over time this o-ring will shrink, become brittle and crack allowing for air leaks. At that time it should be replaced. It is made out of rubber and it is sold individually. Replacing this item you would need hex key/allen wrench and pliers to replace this item.

This is an authentic OEM component from Chicago Pneumatic. The protective retainer buffer is made for use with the CP7120 (8941071200) Needle Scaler, and is fastened to the driver retainer on the barrel. The retainer buffer is sold individually. A flat head screwdriver and a pair of pliers may be necessary for the installation.