Bosch Washer Latches

Your Price

$105.51

Bosch Washer Electrical Door Lock

★★★★★

5 Reviews

PartSelect Number PS8727513

Manufacturer Part Number 00612148

If the door on your washing machine will not close, or if your washer will not start, there could be a problem with the locking system. This electrical lock is designed to firmly hold the door of your appliance closed while it completes both the washing cycle and the spin cycle. If this lock is broken or damaged and the door cannot close, it will prevent the washer from operating. This door lock assembly is approximately 3 inches long, and 5 inches wide. You will need a screwdriver to successfully replace the locking mechanism on your washing machine.

Fixes these symptoms

Lid or door won’t close
Locking Issues
Will Not Start
See more...

Installation Instructions

Don from MADISON, CT

the door would not latch because the door latch mechanism was broken

i first looked on line to see if there was a video to replace the door switch/lock mechanism. i found one for a different model and it mostly applied. the steps to complete the repair are as follows: 1. disconnect the plug, 2. open the door and remove the garter spring that holds the door seal boot onto the front of the washing machine. 3. roll the boot back to access the door lock. 4. unsnap the retaining bracket. there is limited but enough space to grab the switch. a plastic retaining bracket snaps to the back of the switch. it's a little tricky to pull the switch out but it's possible to unsnap the bracket. 5. pull the switch out of the square hole in the washer front. there aren't any screws on this model washer. the switch is held in place by a groove on one side that slips over the front and the plastic retaining bracket. 6. disconnect the electrical plug. again, there's not much space. the clip that retains the plug in on the switch and it must be pushed out of the way before the wiring plug will come out. it's tough because of the limited space. 7. pull the switch out. 8. remove the manual unlock pull rod from the old switch. install the new switch by 1. reconnecting the electric plug. 2. push the switch into the square hole on the washer front. it goes in on an angle so the groove in one side of the switch goes over the washer front. 3. reclip the plastic retaining bracket. 4. replace the manual unlock rod. this is tricky because it's all be touch. 5. replace the door seal boot. pull it over the ring on the washer front. make sure the seal is properly set in the groove around the door opening. 6. reinstall the door seal garter. this is really tough because the spring is pretty stiff and the wire will want to pull the boot from the groove. i first put the garter about 3/4 of the way around and used some spring clamps to hold it in position while i pulled the spring over the rest of the way. the spring only goes on the boot closest to the door. and that's all there is. i also ordered the "latch" but it was not needed. Read more...

Your Price

$60.39

Bosch Washer Elect. Lock

PartSelect Number PS11766558

Manufacturer Part Number 10000916

This genuine Bosch electric door lock ensures your washing machine door stays securely closed during operation, providing safety and proper function throughout each cycle. Designed for reliability, it replaces older components and helps maintain consistent performance. If your washer door won’t lock or the machine won’t start, installing this replacement part can restore normal operation. Installation is simple—disconnect power, remove the old lock, and secure the new one before reconnecting.

Your Price

$79.85

Bosch Washer Lock-mechanical

PartSelect Number PS8730790

Manufacturer Part Number 00648526

This mechanical lock ensures secure operation. Replace if latch fails. This part is designed to keep your appliance operating reliably and efficiently. Replacing a worn or failing component helps prevent further issues and can extend the overall lifespan of your unit.

Fixes these symptoms