Alpha Parts

This is an authentic component which is sourced directly from the original equipment manufacturer for use with Alpha pneumatic air polishers. The vane is made of layered fabric and laminate and is used to spin the rotor. It is designed to slowly wear down over time, to avoid damage to the cylinder. It is advised to replace all rotors at the same time for even wear. Keep in mind this high-quality vane is sold in a pack of four. Please make sure to check the appropriate diagrams of your model for the correct location and installation of these parts. You may need a screwdriver and a wrench set to take the tool apart in order to perform this repair.

This is a genuine item that is supplied directly from the original equipment manufacturer for Alpha polishers. It is an identical replacement for part provides a missing or a faulty component that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality spiral bevel pinion is made of durable metal and is sold individually.

This replacement carbon brush set is specially made for Alpha cutters. It is an authentic item that is sourced directly from original equipment manufacturer. They play a key role in electric motors by conducting the current. This set includes two carbon brushes with lead wires and springs attached. It is recommended to replace both brushes at the same time. Please note, brush holders are sold separately. You will need a screwdriver to complete this repair.

This item is an original part from Alpha for use in polishers. The spiral bevel gear attaches to the bearing. You may need a wrench when replacing this part. This item might break over time and will need replacing. It is made of durable materials and is sold individually.

This is an authentic OEM sourced part which is specially designed for Alpha pneumatic air polishers. The bearings are generally utilized to reduce the friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Unfortunately, over time components will wear out and may begin to fail eventually requiring a replacement. Keep in mind this high-quality ball bearing is made of durable metal and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware.

This replacement carbon brush is a genuine OEM sourced component that is specially designed for use with Alpha wet-dry polishers. Carbon brushes are a commonly replaced part on power tools. Due to normal use and friction brushes will gradually wear down and will require replacement. It is advised to replace both brushes at the same time. Please note this high-quality item includes two carbon brushes with attached lead wires per order.

This is an authentic Alpha replacement part that has been sourced from the original manufacturer to be used with pneumatic polishers. The metal bearing is used to reduce friction between the spinning rotor and the fixed housing. This bearing is sold as an individual replacement part.

A faulty brush connection can cause a cutter or saw to start poorly, stop without warning, or produce weak motor power. The brush terminal assembly forms part of the electrical path leading to the motors carbon brush. Check for heat damage, loose connections, broken wires, or worn insulation before replacement. Also inspect both carbon brushes and the armature for cracks, pitting, burning, or uneven wear. Order by the exact tool model because similar machines may use different electrical components. Disconnect the power cord and water line before service, allow the tool to dry, and note the original wire routing. Keep wires away from moving pieces when reassembling the housing.

An authentic OEM sourced part that is supplied for use with Alpha pneumatic air polishers. This is a high-quality replacement for a missing or damaged exhaust hose included with the new unit, make sure to refer to the appropriate diagrams of your model for the correct application of his component. It is made of high-quality leather material and is sold individually.