Wrench Hardware

Genuine OEM replacement part, this item is sold individually. This screw is used in various places in all of the tools listed below The most common use for this screw is to secure plastic housings together. It has a Torx T-20 head.

This is a genuine Milwaukee replacement part, it is sold individually. The Milwaukee Belt Hook is attached to the bottom of the handle assembly on the tool model numbers shown below. Its purpose is to hook the tool to your belt when not using the tool. The Belt Kit includes the screw to attach it to the housing of the tool.

This replacement clip is an authentic OEM component which is made for Makita impact wrenches. The part is secured in the anvil and it helps to apply tension on the socket to secure it. Over time it may wear out and lose tension eventually requiring a replacement. If a socket does not stay put on the anvil, a faulty or a damaged clip may be the cause. Make sure to refer to the appropriate diagrams of your model for the exact location and the correct installation of this clip. One durable metal item is included. You will need pliers to remove the old one and secure the new one in the anvil.

This is an authentic replacement part that is sourced from the original manufacturer for use with hedge trimmers. The special screw is commonly used to secure the front guard assembly. This screw is sold as an individual replacement part, please note four screws may be required.

This is a genuine Dewalt replacement part designed for use with a variety of power tools. It is a standard hardware which has multiple applications based on your tools. This is a metal torx T-10 screw which is sold individually.

This authentic Makita replacement part is designed for use with impact wrenches. This pin fits in the anvil and it helps to hold sockets in place. This part is made out of metal and it is sold individually. To complete this repair you would need a screwdriver and pliers.

This is a pivot pin designed for use in impact wrenches and drivers. Its purpose is to connect the hammer and the anvil, allowing the hammer to move back and forth and drive the bit into the material being worked on. The pivot pin measures approximately 0.5 inches in length and is sold individually as a genuine OEM part made of high-quality metal. Because this is a high-wear component, the pivot pin can break or malfunction over time, necessitating replacement. If you notice that the assembly feels loose or wobbly, it is advisable to inspect the condition of this pin. If it is damaged or compromised in any way, it should be replaced. To replace this pin, you will need a punch and hammer to release the old pin, as well as a set of pliers to hold the detent pin in place when installing the new pivot pin.

This is a genuine OEM part. The Ingersoll Rand reverse valve knob screw is compatible with the 231C 1/2" Drive Air Impact Wrench. The metal screw fastens the reverse valve knob onto the housing, and is sold individually. You will need a hex key for the repair.

This is a genuine OEM sourced replacement part designed for use with nailers/staplers. It allows you to secure your tool to your belt for easy access. It is made out of metal and it is sold individually. Please note the screw used to secure it to the housing is sold separately.