Whirlpool Trash Compactor Switches
GET YOUR OFFICIAL Whirlpool PARTS TO ENSURE VICTORY
Shop By Part Type
View MorePopular Whirlpool Trash Compactor Switches
- Compactor ram gets stuck
- Doesn’t stop at end of compacting cycle
- Noisy
I took out the four screws that kept the top cover in place to expose the ram.
The gear shafts were turning but the ram would not lower, at first I though the ram drive bolts were stripped and it wouldn't engage the shaft. Then I realized there was a mechanical ... Read more directional\limit switch at the top that controlled the power and direction the gear shafts were turning, this switch was broken.
Just had to take off the front plate that was held on by a number of screws and replace the switch that was held on by two more screws. It had five wires attached to it, the new switch was clearly labeled as to which color wire went where.
Remove screws holding compactor to counter
screw in adjustable feet a short distance
slide compactor out far enough to unplug
loosen top screws that hold tiedown strips and move tie down strips out of way
remove two phillips screws on control panel
push control panel assymbly up and ou ... Read more t of front of compactor
remove and replace wires one at a time onto new switch
remove two phillips screws on old switch and removeswitch.install new switch with same screws
install front switch assy by inserting in front panel of compactor and pushing down untill two holes match up for phillip screws.
install screws
realign both tie down straps and tighten screws
plug in compactor
push compactor back into place
level compactor with adjustable feet
replace tiedown screws to underside of counter
replace compactor drawer
push on/off switch to on. push start switch to start compactor.
watch as compactor stops at end of cycle. Hurrah!!
Thank you
MAKE THIS REPAIR A GUARANTEED WIN
OVER 2 MILLION PARTS TO ENSURE VICTORY
Replaced the drawer switch in the lower back (broken)
Replaced the top up/down switch (old and faulty)
Replaced the nylon ram nuts.
Replaced the control panel on/off/start switch.
Replaced the chain, and chain gear set.
Replaced ... Read more the motor.
Replaced both sets of drawer rollers.
Final cost in parts - $450 - new compactor $1100. Works like new.
Had to be creative in the 2 drawer switch as they are now longer offered for sale. Found suitable replacements.
This may be my last chance at repairing this.
removed the faceplate (2 screws)
removed the switch assembley (2 screws)
took wires off old switch, and placed on the new.
replaced all the screws
Bingo, works great.
Saved $150 labor and service call.