Westinghouse Freezer Hardware
Find your part
Enter your model number or a part number and click "Search"
Popular Westinghouse Freezer Hardware
Screw
PartSelect Number PS1525803
Manufacturer Part Number 218755504
Sold individually.
This is a genuine part. The handle mounting shoulder screw (no.10 ab) is made for use with many refrigerators. The metal screw helps to fasten the handle assembly to the outer door panel. The handle mounting shoulder screw is sold individually. For the repair, you will need a pair of pliers.
Installation Instructions
Nancy from LEHIGH ACRES, FL
No problems
I had no problems. Screws arrived sooner than expected. It was a very simple installation. Very pleased with both the product and service.
Read more...
Hinge Mounting Hexagonal Screw
PartSelect Number PS1526054
Manufacturer Part Number 240578902
Sold individually.
Fixes these symptoms
- Door won’t open or close
- See more...
Installation Instructions
Janice from Osseo, MI
Gasket Retainer Clip Kit - 24 Pieces
PartSelect Number PS469567
Manufacturer Part Number 5303922007
This gasket retainer clip kit is for freezers. There are 24 pieces in this kit. The clips are what secure the gasket and liner to the freezer lid. The clips are white in color and made of plastic. If you notice frost build up in your freezer or that is it is not maintaining its temperature, this might be because the retainer clips have broken, and this has caused the gasket to become loose. This is a genuine OEM part that is obtained right from the manufacturer, ensuring a quality repair.
Fixes these symptoms
- Frost buildup
- See more...
Installation Instructions
Rick from Nevada, MO
Inside Door Panel Broke
Removed door from freezer, took panel off and removed insulation to let the ice thaw, reinstalled insulation and door panel , then put door back on freezer appt. 45 Mins.
Read more...
SCREW
PartSelect Number PS417085
Manufacturer Part Number 131168200
Sold individually.
Installation Instructions
Glenn from Fort Worth, TX
Dryer squealed loudly
First, I removed the top panel which is held on at the front by pressure clips. Second, I removed the entire front panel which entailed removing 2 screws and 2 wire couplings. Third, I removed the 3 screws on the inside center of the drum which turned out to be unnecessary. Fourth, I slid the drum forward in order to access the rear bearing. Lastly, I replaced the entire bearing assembly including the shaft, bracket, bearing, grounding ball and clip. Again, probably not needed but I had ordered the parts in advance in preparation for the worst.
Read more...
Single Gasket Retainer Clip
Ordered only one spare plastic clip. Too expensive to invest in more. Luckly only broke one of the old clips.
Carefully pulled clips with small claw hammer. Read more...
PartSelect Number PS457511
Manufacturer Part Number 5303212828
This genuine OEM freezer gasket retainer clip is used on refrigerator freezers, and connects the inner door panel and door gasket to the outer door panel. The gasket is the rubbery strip that seals the space around the edge of the door to keep warm air out of the freezer. When the gasket is not working properly, you may notice an excessive frost buildup or reduced cooling. If the gasket is hanging loosely from the door, the issue could be with the retainer, or the clip fastening the retainer to the gasket, and it should be replaced.
Fixes these symptoms
- Frost buildup
- See more...
Installation Instructions
Michael from Milan, TN
Old panel lid broken and brittle
Removed lid and placed upside down on floor. Pulled plastic retainer clips and removed gasket. Removed old panel. Repositioned new panel and reversed assembly.Ordered only one spare plastic clip. Too expensive to invest in more. Luckly only broke one of the old clips.
Carefully pulled clips with small claw hammer. Read more...
Aluminum Heater Strap
PartSelect Number PS473194
Manufacturer Part Number 5308000110
This strap is designed for use with the evaporator in your refrigerator. The function of this part is to hold wires, tubes, defrost heaters and other parts in place. If you notice that any of these parts are not held in place properly, you will most likely need to replace the refrigerator strap. This part is made entirely of thin metal. The part is very bendable, and the smaller end is designed to fit inside the large one. This part is sold individually. It is an OEM part sourced directly from the manufacturer. Many of our customers have rated this repair as easy.