Waring Parts

This is a genuine Waring replacement part. Sold individually. This gasket provides a tight seal between the main blender jar and the blending assembly, preventing liquids from leaking out. Made from food grade Silicone Rubber. No tools are required for repair, simply replace the gasket and continue blending. This part is compatible with the Waring blender models listed below.

Genuine Waring replacement part, this item is sold individually. This part acts as a seal for the blenders shown below. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these seals and washers will become brittle and compressed, then will have to be replaced.

This is an authentic Waring replacement part, sourced from the original manufacturer for use with blenders. Brushes are items that will wear down over time and eventually need to be replaced. Worn brushes can cause the blender to run off and on, and can prevent the motor from starting all together. This brush is sold individually, please note two brushes are required.

This is a genuine manufacturer sourced replacement part used on Waring blenders. It helps to distribute the pressure evenly and provides a tight seal for the bearing holder. For proper application please refer to diagrams of your unit. This part is made out of metal and it is sold individually.

This is a Genuine OEM sourced replacement part designed for use with Waring Blenders. This is the Blade that cuts food inside the container. It is made out of Metal and it is Sold Individually. To replace it you would need a Wrench or Pliers. • First you want to remove the Nut that secures the old blade assembly • Remove the cutter assembly and make sure to clean the gaskets • Secure the new blade assembly using the Nut

This is a Genuine Manufacturer Approved replacement part used on Waring Blenders. This part consists of Plastic Body and a Metal Blade. Please note the Coupling that drives the Blade is Sold Separately. Replacing this item is easy and does not require any Tools. • Simply remove the Jar Bottom • This will allow for the Blending Assembly to be separated • Remove the Coupling and the Sealing Ring/Gasket • Replace the Blending Assembly with the new one • Reattach the Coupling and the Gasket • Secure the Blending Assembly with Jar Bottom/Collar

This is a genuine manufacturer sourced replacement part used on Waring blenders. It helps to distribute the pressure evenly and provides a tight seal for the bearing holder. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these seals and washers will become brittle and compressed, then will have to be replaced. For proper application please refer to diagrams of your unit. This part is made out of rubber material and it is sold individually. To complete this repair you will need a wrench.

This is a genuine manufacturer sourced replacement part used on Waring blenders. The coupling is the part of a blender that transfers power from the blender's motor to the blade assembly. Over time, the teeth on blender coupling wear down until they no longer engage properly on the blade assembly. It is made out of plastic and it is sold individually.

This is a genuine manufacturer approved replacement part designed for use on Waring blenders. This item fills the center hole in the outer lid. It is made out of clear plastic and it is sold individually.