Toro Engine Parts
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Toro Engine Parts
Toro Engine Oil Seal
PartSelect Number PS9151828
Manufacturer Part Number 795387
This OEM Seal-Oil (PTO Side), also called the Oil Seal, is a Black, Nitrile Rubber, 2/14 O.D., individually sold part which is installed using a Seal Puller. Customers rate the installation difficulty as Medium.
This part provides a seal around the crank shaft and engine block. When installing onto the engine block around the crank shaft, use something that makes contact around the entire seal, like a large socket or pipe, and tap into place evenly, ensuring that the housing is clean and dry. If the part is broken, likely due to fatigue, there will be leaking oil, and this part should be replaced using the model number on the original part to confirm it is the right fit for your model.
Installation Instructions
rodney from MUSCATINE, IA
governor not working
Had to pull the engine off the rider mower. Drained the oil took shield off the flywheel. Set it upside down on a 5 gal bucket. Took a 7/16 hand wrench to remove governor lever from bottom of engine. Left it in its location. Pulled 10 1/2 " bolts. Split engine case. Found the old governor had broke into pieces. Had to use a magnet to remove all the pieces. Removed the small clip and removed gear. Lubed shaft slid new on put new clip on. Lined governor weights with center piece tapped it in place very lightly. Cleaned gasket flanges pulled the shaft seal. Used the old seal as a seal driver. When putting the cover back on make sure the seal dont roll out. Take a mini screwdriver and tuck it in around shaft. Put bolts back in and tighten like instructions
Read more...
Toro Engine Pump-fuel
PartSelect Number PS16869209
Manufacturer Part Number 597338
This is a fuel pump for various models of lawn tractors and lawn mowers, as well as other small engines. Fuel pumps are used to deliver fuel to the engine from the fuel tank and help prime the engine as well as keep the engine pressure regulated. Made of high-quality black plastic, this fuel pump has 3-line attachments for the tank, carburetor, and vacuum, as well as a copper-brass vent. If you notice your engine emitting unusual noises, misfiring, or having difficulty starting, this fuel pump may need to be replaced. This is an individual OEM part, meaning it does not include any other parts, such as fuel lines or clamps. Replacing this pump will require you to drain the fuel from the system before disassembling this pump, as well as a set of pliers to remove the fuel lines and clamps.
Toro Engine Gasket-rocker Cover
PartSelect Number PS9062980
Manufacturer Part Number 690971
Authentic Manufacturer Sourced replacement part used on a variety of Engines. This rocker cover gasket is for the cylinder head. It is sold Individually. It provides a strong seal to protect from leaks. Over time gaskets tend to deteriorate and would need to be replaced.
Toro Engine Oil Filter
PartSelect Number PS9883966
Manufacturer Part Number 1205001-S
This genuine OEM oil filter helps to remove harmful contaminants from engine oil. It is designed for a variety of Engines. It is sold Individually. This part maintains optimum performance of your engine in accordance with applicable EPA emissions regulations. It is recommended to replace an Oil Filter at least once a season.
Toro Engine Rod, Push
PartSelect Number PS16383228
Manufacturer Part Number 597785
This aluminum OEM push rod is found in your lawn mower. It operates on the camshaft and pushes the exhaust valve open during the exhaust stroke. If you notice that the push rod is bent, it needs to be replaced. A damaged push rod can cause unusual clicking, tapping, or knocking sounds to come from the engine. It can also lead to improper valve operation, resulting in engine misfiring, loss of power, or uneven running. To replace the push rod, you will need to locate and access the valve cover. It is advisable to gather a screwdriver, pliers, a socket set, a wrench set, and a torque wrench for this repair. Please note that the replacement part is sold individually.
Fixes these symptoms
- Engine misfires
- See more...
Installation Instructions
Robert from WHITMAN, MA
the head blew a vaulve guide destoying push rods
about 6 hours to tear down and replace don't do it in the hot sun needed more breaks takes longer, but the new factory heads did it started up 185 lbs of compression almost back to new, so much more power than old one's. FYI take off the motor cover every year clean out the debris (grass-mouse nest- and oil) it blocks the air and COOKS THE HEAD it only takes short time and will make that motor last a little longer but it is a BRIGGS engine
Read more...
Toro Engine Gasket-float Bowl
PartSelect Number PS9064482
Manufacturer Part Number 693981
This is a Genuine OEM Authorized Gasket used on variety of Lawn and Garden Equipment Engines. This part is made out of Rubber and it is sold individually. If the carburetor is leaking fuel it is recommended to replace the Bowl Gasket. Gaskets and O-rings are a common source of problems. They eventually shrink, causing fuel and air leaks that lead to poor engine performance. When replacing this Gasket you would need a Screwdriver and a set of Wrenches.
Toro Engine Oil Seal
PartSelect Number PS9277860
Manufacturer Part Number 391086S
The Oil Seal is a manufacturer-approved rubber part which provides a seal between the crankcase and crankshaft by attaching around the axle shaft on the crankhouse housing. Installation is rated as "Medium" difficulty and requires a screw driver, wrench set and seal puller. A broken seal will cause a leak, and the part must be replaced. Refer to your make, model and diagram to ensure you're choosing the right part. This part comes in black and gray.
Toro Engine Carburetor Overhaul Kit
Would be nice to have a fuel line kit with the big fuel line (tank to carb) and the little one (carb to engine) together with all the necessary clamps. Read more...
PartSelect Number PS8984098
Manufacturer Part Number 498260
This is a replacement carburetor overhaul kit for your small engine. The carburetor is essential to the overall performance of your engine, and the carb can get clogged up over time for a variety of reasons. When your carb becomes clogged, it is often a good idea to take it apart and replace the various parts inside by purchasing a carburetor kit. This is a 15-piece set and contains everything that you will need to do a total overhaul of your carburetor. You may want to purchase some carb cleaner as well, to ensure that the new pieces in the carb kit fit and adhere properly.
Fixes these symptoms
- Engine will not idle
- Will Not Start
- See more...
Installation Instructions
Jonathan from LIBERTY TWP, OH
Smelled Gas Leaks
Inspected/removed fuel lines and found signs of leak. Removed and inspected carburetor and found that seals and gaskets were toast. Replaced said seals with ones from the kit that fit and replaced fuel lines.Would be nice to have a fuel line kit with the big fuel line (tank to carb) and the little one (carb to engine) together with all the necessary clamps. Read more...
Toro Engine Armature-magneto
PartSelect Number PS9045176
Manufacturer Part Number 591459
Discover the Briggs and Stratton Armature-Magneto, a vital component for optimal operation of your lawn and garden equipment engines. This premium-quality ignition coil significantly contributes to spark plug voltage generation. It's recommended that you suit up with work gloves before you start the installation process to ensure your hands are completely protected. For your convenience, we provide a comprehensive installation guide, which consists of helpful DIY instructions to assist you in properly setting up the part. Trust only Briggs and Stratton for dependable equipment parts that offer long-standing durability and improved performance.
Fixes these symptoms
- Will Not Start
- See more...
Toro Engine Recoil Starter Assembly
PartSelect Number PS8981884
Manufacturer Part Number 497680
This authentic OEM starter assembly is designed for use with lawn and garden engines and is sourced directly from the original manufacturer to ensure quality and compatibility. The assembly includes a durable plastic shroud/housing, starter pulley, recoil spring, pull rope with grip, and the necessary hardware for installation. It functions as the primary mechanism for manually cranking and starting the engine. To complete the replacement, you’ll need a wrench. Simply remove the four screws and nuts securing the old starter assembly, then install the new one using the included hardware. This item is sold as a complete individual assembly.
Fixes these symptoms
- Cannot pull starter cord out or engine will not turn over
- See more...
Installation Instructions
Seikai from MARICOPA, CA
starter rewind cord broke
I found the model number of the Briggs & Stratton engine on the inside of the engine housing. Ordered a new starter-rewind unit, as the old cord broke and the thing was well worn. The instructions were clear enough, but to get the old starter off I had to drill out four rivets, which just spin around when you try. I used a hacksaw, chisel, pliers, whatever worked on each rivet; this took a while. When they were finally removed, the new starter pull unit was relatively easy to install with the small nuts and bolts provided. On the Yard Machines log splitter, putting back the engine housing is quite tricky; you have to jostle the thing into place, get the pull handle above the cover and line up the bolt holes.
Read more...
Toro Engine Appliance Types
Popular Toro Engine Models
Below are the most popular Toro Engine models we have. Enter your model number in the search box to find your model.
- 44900 (60001-69999) 44900/Serial: 60001-69999
- 44900 (70001-79999) 44900/Serial: 70001-79999
- 44900 (40001-49999) 44900/Serial: 40001-49999
- 44900 (30001-39999) 44900/Serial: 30001-39999
- 44900 (230000001-230999999) 44900/Serial: 230000001-230999999
- 44900 (250000001-250999999) 44900/Serial: 250000001-250999999
- 44900 (20101-29999) 44900/Serial: 20101-29999
- 44900 (50001-59999) 44900/Serial: 50001-59999
- 44900 (290000001-290999999) 44900/Serial: 290000001-290999999
- 44900 (260000001-260999999) 44900/Serial: 260000001-260999999
- 44900 (240000001-240999999) 44900/Serial: 240000001-240999999
- 44900 (200000001-200999999) 44900/Serial: 200000001-200999999
- 44900 (210000001-210999999) 44900/Serial: 210000001-210999999
- 33125 (00001-09999) 33125/Serial: 00001-09999
- 33125 (60001-69999) 33125/Serial: 60001-69999
- 33125 (70001-79999) 33125/Serial: 70001-79999
- 33125 (90001-99999) 33125/Serial: 90001-99999
- 33125 (10001-19999) 33125/Serial: 10001-19999
- 33125 (50001-59999) 33125/Serial: 50001-59999
- 33125 (80001-89999) 33125/Serial: 80001-89999