Tiller Switches

Tiller Trimmer Switch This Switch is a black, plastic on/off switch for a trimmer. Installation of this manufacturer-certified switch is rated as "Easy" and requires a screwdriver, wrench set and socket set. Refer to your make, model, and diagrams to ensure this switch is correct for you.

Tiller Wire- Stop Switch - 370mm

Tiller Lawn Mower Single Pole Switch

Tiller Engine Stop Switch

Tiller Trimmer On/off Switch

Tiller Leaf Blower On-off Switch This manufacturer-approved on/off switch is a control mechanism that allows users to easily turn their outdoor power equipment on and off as needed. It can be found near the control panel or handlebars, within easy reach of the operator. The switch is connected to the ignition coil, and it works by either completing or breaking the circuit between the spark plug and the ignition coil, to either start or stop the engine. If the switch wires are faulty or the switch is damaged, the equipment will either run continuously or fail to start altogether. To remove and replace the off/on switch, first ensure that the equipment is switched off. Disconnect the wires from the faulty switch and pull the switch off the mounting post. Take the new off/on switch and reconnect the corresponding wires. Secure the switch in place by reattaching the appropriate fasteners.

Tiller Switch

Tiller Trimmer Ignition Switch

Tiller Switch Assembly. Engine Stop

Tiller Lawn Mower Ignition Switch: 5 Pin This OEM 5 Pin ignition Switch is a silver, steel, individually sold part. It can be installed using a wrench and screwdriver, and has been rated as Easy to install. The part attaches to the dashboard, and is used to start and shut off the engine. If it is broken (likely due to fatigue), you will no longer be able to start or stop your engine and the part must be replaced. Refer to your owners manual or model number to ensure you are purchasing the correct part.