Tiller Handles

This is the lower handle for various models of walk-behind lawn mowers. This handle is made of durable black metal and attaches directly to the rear of the lawn mower. This handle is an OEM part that is sold by itself and does not come with any hardware or other parts. If your current lower lawn mower handle is corroded or damaged, it needs to be replaced immediately so you can properly and safely handle your lawn mower. This handle measures approximately 24.5-inches long and 17-inches wide and connects the rear of the lawn mower with the upper and main handle that the user holds when operating the lawn mower. Replacing this handle will not require any tools but must start with turning off the lawn mower. Loosen and remove the knobs around the handle, including the ones connecting the lower handle to the mower and those securing the upper and lower handles. Once each knob is removed, replace the old lower handle with the new one, and resecure • all the knobs onto the handle(s).

This is an authentic OEM part from Husqvarna for use with Tillers. The throttle control assembly attaches to the handle and the carburetor to control the engine speed. The most common reason for replacing the throttle control assembly is if the throttle is unresponsive, stuck open (or closed), the throttle cable is rusted, broken or the throttle trigger handle is broken or cracked. This part is sold individually. Here is a list of tools that are needed to replace the throttle control assembly wire cutters, long-nosed pliers, wrench socket/ratchet set and a small screwdriver.

This OEM plastic throttle trigger and rubber-insulated cable in your lawn equipment control the fuel and air flow to the engine, determining its speed and power. They are typically located on the handle, with the cable connecting to the carburetor. If these parts are broken, you will notice an unresponsive trigger, fixed engine speed regardless of trigger position, or difficulty starting or stopping the engine. To remove the throttle trigger and cable, consult your user manual for specific instructions. Remember to turn off and cool down the machine, disconnect the spark plug wire, and use a screwdriver to remove any fasteners on the trigger. Trace the cable from the trigger to the carburetor and release any clamps or clips holding the cable in place. Finally, pull the throttle trigger away from the handle and remove the cable from its housing. Please keep in mind that this trigger and cable set does not come with the housing or other components.

This is a genuine Honda part sourced directly from the manufacturer for use in lawn mowers, engines, tillers, and snow blowers. The upper handle joint grip is made of plastic and metal and attaches to the upper handle pipe. No tools should be needed during the installation of this item. It may become stripped or broken and will need to be replaced. This is available as an individual replacement part.

This is a genuine manufacturer-sourced replacement control lever for the throttle cable, it is specially designed for Echo handheld lawn and garden equipment. The throttle cable is connected to the carburetor and it stops the engine when you shift the lever to the full choke position. This high-quality component is made of durable plastic and is sold individually, please note the cable and other components are all sold separately.

This is a genuine manufacturer-sourced component which is specially made for use with Troy-Bilt trillers. It is a high-quality replacement for a missing or a damaged upper handle that was installed on a new unit. The purpose of this assembly is to provide a user with a comfortable grip to operate the unit. Note, this part is made of durable metal and is sold individually. Make sure to check the owners manual and the appropriate diagrams of your model for the correct installation of the part. You will need a wrench set to remove the hardware from the old assembly and secure the new upper handle.

This upper handle provides user control and support during operation. Built for strength and comfortable grip, it supports safe handling and reliable maneuverability.

This upper left handle is designed to restore proper control and structural support on small cultivators and tillers. Forming part of the upper handlebar assembly, it helps the operator maintain balance, steering, and stability while working the soil. Made for durability and a direct fit, it’s an ideal replacement for a bent or broken handle to return the machine to safe, reliable operation.