Tiller Engines

This piston ring is an authentic manufacturer approved replacement part. Is is commonly used on Echo gas trimmers/edgers. The purpose of a piston ring is to create an air tight seal inside the cylinder. A worn or broken piston ring will allow combustion gases to escape the seal and enter the crankcase. This would cause low compression and a loss of power. Replacing an o-ring should resolve this issue. This part is made out of metal and is sold individually. To complete this repair you will need a set of wrenches, pliers and a screwdriver. • Remove the air cleaner • Drain the fuel • Remove the air cleaner case • Remove the carburetor • Remove the intake insulator • Remove the spark plug • Remove the engine cover • Remove the insulator gasket • Remove the starter assembly • Remove the fuel tank • Remove the air duct • Separate the engine • Bind the engine • Remove the clutch • Remove the flywheel • Remove the starter pulley • Unbind the engine • Remove the muffler • Separate the cylinder from the crankcase • Remove the piston ring • Install the piston ring • Reassemble and test the equipment

Honda engine oil, SAE 10W-30, One quart

This is a genuine OEM sourced replacement part that has been sourced from the original manufacturer to be used with trimmers, hedge clippers, pruners, edgers, and blowers. The piston fits inside the cylinder and links with the connecting rod. The piston is used to separate the combustion chamber and the crankcase. The piston moves up and down inside the cylinder during the ignition sequence and this action drives the crankshaft. This kit includes the piston, ring, clips, and pin.

This is an OEM Honda part directly sourced from the manufacturer for use in small engines. The governor rod hooks to the governor arm. You may need a wrench and a set of pliers when replacing this part. This item may become broken or bent and will need to be replaced. It is made of metal and is available as an individual replacement part.

This is an authentic item that is supplied directly from the original equipment manufacturer for the Ridgid digital inspection camera listed below. This battery holder houses four (4) AA batteries (not included) used to power the tool. To remove the old part, simply squeeze the battery clips on the base of the handle and slide out. When inserting the new part, squeeze the clips in again as you firmly insert the holder into the base. This item is sold individually.

This is an original replacement part sourced directly from the manufacturer. The governor rod is commonly found in Honda small engines. This part is made of metal, and is attached to the governor arm. You may require pliers when replacing this product. This item is sold as an individual replacement part.

This is sold as a set that contains three rings. The rings attach to the piston and help to create a seal. When replacing these parts a screwdriver, a set of pliers, and a socket set might all be required during the installation process. These parts are made out of metal and will need to be replaced if they break or bend. They are authentic Briggs & Stratton and Toro replacement parts that are sourced from the original manufacturer for use with engines, generators, tillers, and blower-vacuums.

The valve tappet attaches to the push rod. It is made out of metal and is sold individually. This is a Briggs & Stratton and Toro replacement part directly sourced from the manufacturer for use in engines. It may require a set of pliers during installation. This part may become broken and will need to be replaced.