Tile Saw Brushes

This is a genuine OEM sourced replacement part designed for use with Ridgid tile saws. This assembly includes one (1) carbon brush with a lead wire and a spring attached. Please note brush holder is sold separately. Carbon brushes are a commonly replaced part on power tools. Due to normal use and friction brushes will gradually wear down and will require replacement. It is advised to replace both brushes at the same type. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • First remove brush caps • Take out old brushes and replace them with new ones • Secure brush caps

This replacement carbon brush set is specially made for Alpha cutters. It is an authentic item that is sourced directly from original equipment manufacturer. They play a key role in electric motors by conducting the current. This set includes two carbon brushes with lead wires and springs attached. It is recommended to replace both brushes at the same time. Please note, brush holders are sold separately. You will need a screwdriver to complete this repair.

This is a manufacturer sourced replacement part used on a MK Diamond tile saws. It includes two (2) carbon brushes with lead wires and springs attached. Carbon brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. It is recommended to replace both brushes at the same time. You would need a screwdriver and pliers to complete this job. • First remove screw holding the cover • Remove the housing/cover to gain access to armature and brushes • Remove the old brush • Install the new brush • Reassemble and test your tool

This is an authentic DeWalt replacement part has been sourced from the original manufacturer and is intended to be used with tile saws. The carbon brushes are part of the motor assembly. The brushes are used to relay electricity from the switch to the armature's commutator. These brushes are sold in a pair.

A faulty brush connection can cause a cutter or saw to start poorly, stop without warning, or produce weak motor power. The brush terminal assembly forms part of the electrical path leading to the motors carbon brush. Check for heat damage, loose connections, broken wires, or worn insulation before replacement. Also inspect both carbon brushes and the armature for cracks, pitting, burning, or uneven wear. Order by the exact tool model because similar machines may use different electrical components. Disconnect the power cord and water line before service, allow the tool to dry, and note the original wire routing. Keep wires away from moving pieces when reassembling the housing.