Snow Blower Switches

The stop switch is made of plastic and metal and helps to turn off the device. This is an authentic replacement part that is sourced from the original manufacturer for use with engines, generators, snowthrowers, and blower-vacuums made by Toro, Murray, and Briggs & Stratton. This part is available individually. During the installation process, a wrench set and wire stripping pliers might be needed to replace this part. It may become bent or broken and will need to be replaced.

This is a replacement part sourced from the original manufacturer for use with garden tractors made by Craftsman. This switch engages the electric clutch to spin the blades. This part is made of durable material and sold individually. It is recommended to review your models diagram to verify the parts compatibility.

This snap-mount PTO switch turns the mower blade clutch on and off. It has a red push-pull knob and five electrical terminals. Pulling the knob engages the blade system, while pushing it down shuts the blades off. Replace the switch if it is damaged or no longer controls the clutch correctly. Match the terminal layout, panel opening, mower model, and serial number before ordering. Disconnect the battery before installation. This is a genuine OEM part sourced from the manufacturer directly.

This is an authentic replacement ignition switch. It is sourced from original manufacturer and it is specially designed for use on Toro snow throwers/blowers. It allows user to start their equipment using a simple ignition turn key (sold separately). This switch has a plastic body and two metal wire terminals/prongs. Includes one (1) switch per order. Replacing this switch is a simple task that generally does not require any tools. • Reach under cover/housing and disconnect cord from the old switch • Pull out switch • Secure new switch in place • Reconnect power cord and test the unit

This is an authentic replacement part sourced directly from the manufacturer. The stop switch wire is commonly found in Honda small engines. This part is made of metal wire with a flexible plastic casing, and is used to send signals from the engine stop switch to the engine. You may require a wrench and pliers when replacing this item. This product is available as an individual replacement part.

It is a high-quality replacement for a faulty, a damaged or a missing switch-rocker that was installed on a new unit. It is the switch which allows a user to adjust the cutting height. Unfortunately, over time parts can wear out or get damaged eventually requiring a replacement. Make sure to check the appropriate diagrams for your model to ensure the correct repair procedure. Please note, this high-quality switch is sold as an individual item. It is a genuine manufacturer-sourced part which is specially designed for Murray, Snapper and Simplicity lawn mowers.