My Orders
Simplicity Chipper Shredder Tanks and Containers
GET YOUR OFFICIAL Simplicity PARTS TO ENSURE VICTORY
Popular Simplicity Chipper Shredder Tanks and Containers
This fuel tank is a genuine OEM replacement part supplied by the original equipment manufacturer. It is commonly used in engines, shredders, and snowthrowers. This black fuel tank is made of plastic. It should be replaced if it is cracked, broken, or damaged. To replace this part, simply remove the brackets with a screwdriver. Please note the cap is included with the purchase of this part.
This fuel tank is a genuine OEM replacement part supplied by the original equipment manufacturer. It is commonly used in engines, shredders, and snowthrowers. This black fuel tank is made of plastic. It should be replaced if it is cracked, broken, or damaged. To replace this part, simply remove the brackets with a screwdriver. Please note the cap is included with the purchase of this part.
Installation Instructions
Dennis from EUFAULA, OK
Gas tank leaking, pull starter rivets worn, rope and rope bushing worn
The gas tank was a simple job, close the fuel shut off, remove fuel hose then back out 2 bolts on the mounting bracket. Reverse procedure to mount.
To replace the pull starter/recoil assy. Remove low oil warning light, and air filter housing then remove the 4 bolts holding the front cover. Once the front cover is free remove kill sw ... Read more itch wire
Drill out the rivets holding the recoil housing w/ 3/16 bit. Screws w/ nuts are included to use in place of rivets, I used red Locktite on the screws which hold the started recoil to the front cover. Make sure the pull rope is correctly oriented in the 11:00 position. Replace front cover, four bolts. Air filter housing, kill switch wire and low oil warning light
To replace the pull starter/recoil assy. Remove low oil warning light, and air filter housing then remove the 4 bolts holding the front cover. Once the front cover is free remove kill sw ... Read more itch wire
Drill out the rivets holding the recoil housing w/ 3/16 bit. Screws w/ nuts are included to use in place of rivets, I used red Locktite on the screws which hold the started recoil to the front cover. Make sure the pull rope is correctly oriented in the 11:00 position. Replace front cover, four bolts. Air filter housing, kill switch wire and low oil warning light
Read less
