Saw Power Cords

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

This power cord is for power tools. Unplug the power tool before installing this part. Wear work gloves to protect your hands.

This cord is a genuine Makita replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Over time, power tool cords will wear out or become frayed. We recommend replacing a cord as soon as signs of wear are visible. Power Cord Specifications: • 2 Prongs • 2 Wires • 14 Gauge • 8 Feet Long

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is an effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

This cord protector is a genuine Milwaukee replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.

This power cord includes a cord protector and has connectors attached to the wire ends. It is a genuine Milwaukee replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 2 Prongs • 2 Wires • 14 Gauge • 8 Feet Long

This replacement power cord is specially designed for Milwaukee band saws. It is a genuine OEM supplied part, not an aftermarket imitation. This cord is used to supply power to the tool from a standard outlet. This rubber insulated cord is sold individually. This cord includes a rubber grommet. To complete this repair you would need a screwdriver. • Remove the housing screws • Separate the housing pieces • Disconnect the old power cord wires • Secure the new cord in place • Reassemble and test the tool

This is a Genuine OEM replacement Protector Grommet which is used on Milwaukee Power Tools. This part is made out of Rubber and is Sold Individually. It is important to have a cord protector on your tool to improve friction, seal cable and protect it from a potential damage. Replacing this item would differ based on your tool. • First you would need to gain access to internal connections of Power Cord by removing housing of your tool • Once you have disconnected Power Cord you would need to loop it through the Protector • Re-Connect Power Cord to your tool • Secure Cord Protector in the Housing opening and assemble your tool

This power supply cord is a genuine Makita replacement part. It is a high quality item that is specially produced for circular and hypoid saws. It connects to a standard US outlet to supply power to the tool. This rubber insulated cord is sold individually. Please note, cord protector is sold separately. You will need a screwdriver to complete this repair.