Saw Filters

Saw Gasoline Filter This is a genuine OEM sourced replacement fuel filter. It is specially manufactured for Makita gas powered handheld lawn and garden equipment. This is an in-tank fuel filter that will help to filter out any contaminants from the fuel that does into the engine. Over time it will get clogged requiring replacement. Replacing this filter is a simple task that should only require pliers. • Remove the air cleaner • Drain the fuel • Remove the fuel cap • Remove the fuel filter • Secure the new filter to the line • Reassemble and test

Saw Filter This is a genuine manufacturer-approved replacement part which is specially designed for use with Ridgid tile saws. The purpose of this filter is to ensure that the air that goes through the engine is free of dust and other harmful contaminants. Keep in mind this high-quality item is made of durable foam material and is sold individually. Please make sure to check the appropriate diagrams of your model for the correct location and application of this component.

Saw Filter Disc This is an authentic OEM part for use in grinders, buffers, and sanders made by Dotco and Cleco. The filter disc goes between the motor housing and the filter retainer. During the installation process, a set of pliers might be needed to replace this item. It is made of a felt material and will need to be replaced if it becomes ripped or dirty. Keep in mind this high-quality part is sold individually.

Saw Prefilter This is an original Makita replacement part manufactured for use with power cutters. The filter is the first of three filters, and fits into the cover. The filter is used to stop debris from entering the engine. The filter can be cleaned, but overtime will need to be replaced. Worn out filters can allow debris to pass into the engine, which can damage the piston and cylinder resulting in a loss of compression. The filter is sold individually.

Saw Air Filter Insert, Dpc7331

Saw Inner Filter This is a genuine manufacturer-sourced component which is specially designed for use with Makita power cutters. It is an identical replacement for a missing or a faulty inner filter that was installed on a new unit. The part helps to ensure that the air that goes through the tool is free of dust and other harmful contaminants. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality filter is sold individually.

Saw Pre-filter, Dolmar Ps-7910

Saw Air Filter, Ea5600f "This is an air filter for a chainsaw. If your chainsaw stalls or runs rough, check the filter to see if it is clogged or damaged. If the performance of the chainsaw does not improve after cleaning it or if it is damaged in any way, it will need to be replaced immediately. If large pieces of debris reach the engine, it can cause serious damage to the engine. To remove the old filter, disengage the hood clips with the combination tool and remove the hood. Push up the combination switch and put it into the choke position so debris cannot get into the carburetor. Turn the air filter lock counterclockwise to access the air filter. Be sure to cover the intake opening with a clean cloth to stop any debris from entering the carburetor. When inserting the new filter, place it into position and make sure it is seated evenly. Turn the air filter lock clockwise to tighten. Push down the combination switch and press the throttle all the way down to disengage the throttle lock. Put the hood on and lock it by pushing the hood clips in. "

Saw Air Filter The Air Filter is a Genuine OEM replacement part from Makita. This air filter is found on a Makita Chainsaw and is used to filter dust and debris from entering the carburetor. It is recommended to check the air filter regularly and clean when needed. Over time the filter can become worn down and require replacement to prevent the particles of the filter from clogging the carburetor and engine. This filter is made of a foam material and is sold separately.

Saw Air Filter Cpl.