Saw Blades

Saw Blade Pulley Tire This is a Genuine Milwaukee part It is sold individually Two tires are needed on the Bandsaw. If one tire is worn, it is advisable to replace both at the same time. The purpose of the Blade Pulley Tire is to keep the blade tracking correctly. Over time they will become brittle or stretched out. You then will have the problem of the blade coming off the pulleys or not tracking properly. The tires simply stretch onto the pulleys. No tear down of any parts is needed.

Saw Front Blade Guide Assembly This is a genuine Milwaukee replacement part, it is sold individually. It is used on all the Bandsaw models shown below. The purpose of the Front Blade Guide Assembly, is to keep the blade on the bandsaw blade tracking straight as you are cutting.. It also helps track the blade on the blade pulley. If your Blade Guide Block is in good shape and just the bearings are worn. You can order them individually under part number 02-25-0260. These fit both the Front and Back Guide Block. There are six per tool.

Saw Grinder Grinder/sander Rotor Blade

Saw Blade Pulley Genuine Milwaukee replacement part, this item is sold individually. This is the part of the Portable Bandsaws listed below that the blade is installed on. The part number 45-69-0010 Blade Pulley Tire must be used with the pulley for the blade to track properly.

Saw Blade Wrench This is an authentic OEM sourced item, not an aftermarket imitation. It is specially made for Ridgid and Ryobi table saws. This wrench allows you to secure or remove a saw blade. Angular profile of this item makes tightening and loosening of the blade nut extremely easy.

Saw Blade Spacer This is an authentic manufacturer-sourced component which is specially made for use with Milwaukee compound miter saws. It helps to distribute the pressure evenly and provide a tight seal for the blade. This is an identical replacement for a missing or a faulty spacer that was included with a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality spacer is made of durable metal and is sold individually.

Saw Blade Release Shaft The blade release shaft goes between the needle bearing and the front pulley guard. It is made out of metal and is sold individually. This is an OEM Milwaukee part directly sourced from the manufacturer for use in bandsaws. When replacing this part an allen wrench might be required during the installation process. It will require replacing if it breaks.

Saw Blade Release Lever This is a genuine Milwaukee replacement part designed for bandsaws. It is a black plastic piece that is used to lock or release the blade. Note that this part is secured with the Pan Slot Taptite Screw (part # 06-82-7252) and the Thrust Washer (part # 45-88-7150); both are sold separately. This lever is sold individually.

Saw Blade Guide Assembly

Saw Blade Guide