Sander Valves

Steady sanding performance depends on clean, controlled airflow through the tool. A damaged regulator may cause uneven speed, reduced power, or difficulty adjusting the sander. Inspect the compressor setting, hose, fittings, and nearby valve parts before ordering a replacement. Match the assembly to the full tool model and parts diagram. Shut off and disconnect compressed air before service, bleed any remaining pressure, and protect small internal pieces from dirt. Test the speed control carefully after reassembly and stop if the tool runs unexpectedly.

This is a genuine OEM part. The Dynabrade tip valve is manufactured for use with orbital sanders, finishers and grinders. This metal and plastic valve often sits in the air inlet bushing, and is supported by a spring. The valve is sold individually, please see specific manual for additional repair information. A pair of pliers, wrench and a screwdriver may be necessary for installation.

This is a genuine Dynabrade replacement part manufactured for use with orbital sanders, and grinders. This special valve sits in the air inlet bushing, and is supported by a spring. The valve is sold individually, please see model diagram for additional parts that are available separately.

It is a genuine OEM part that is designed for Dynabrade grinders and sanders. The valve stem is an important component that connects to the speed regulator assembly. It provides an identical replacement for a damaged or a missing part that was installed on a new unit. Check the owner's manual and the diagrams for your model to ensure the proper repair procedure. Keep in mind this high-quality valve stem is made of durable metal and is sold as an individual item. A screwdriver, a wrench set, and pliers might be needed to replace this part.

This part is an OEM from Dynabrade. The speed regulator is made for use with many orbital sander devices. This item holds the valve stem in the housing assembly, and is sold individually. The plastic regulator manages the airflow, controlling the sander speed. You will need a pair of pliers for the installation.

This valve stem is an OEM part direct from Dynabrade. Compatible with many sander devices, the plastic stem is fitted into the speed regulator, assisting with the lever assembly. A screwdriver and a pair of pliers may be necessary for the replacement. The valve stem is sold individually. Please refer to specific manual for repair instructions.