Sander Caps and Lids

This cord guard is a genuine Makita replacement part, and it is a direct replacement for a damaged or missing cord guard. Power tool cords undergo a lot of stress, and these cord guards help to alleviate some of that stress at the weakest point--right where the cord enters the tool. Over time cord guards will deteriorate and eventually require replacement. Keeping a strong cord guard on your tool will help will cord life. This cord guard is compatible with the tools listed below, but it is not guaranteed to fit any other power tools.

This brush cap is a genuine OEM sourced replacement part. It is commonly used on a variety of Makita power tools. This brush cap helps to secure the carbon brush in the brush holder. This cap has external threads that will thread into the opening in the housing. This item is made out of durable plastic and it is sold individually. It has a convenient slot that makes it easy to secure or remove it using only a flat-head screwdriver.

This is an OEM part direct from the original manufacturer. The Makita cord guard 8 is made of durable rubber, and is compatible with various power tools. This item is often fastened into the housing and over the power cord, providing protection to the cord. The cord guard 8 is sold individually. A hex key and a screwdriver are helpful for the removal and repair. Please refer to the specific manual and diagrams for further safety and repair instructions.

This is a genuine item that is supplied directly from the original equipment manufacturer for Chicago Pneumatic sanders. It is an identical replacement for a missing or a faulty cover-motor housing that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality housing is made of durable plastic and is sold individually.

The muffler cap attaches to two muffler inserts and the cone muffler. This part is available as an individual replacement part and is an OEM from Dynabrade for use in sanders. It is made out of plastic and will need to be replaced if it breaks. During the replacement process, a screwdriver may be needed to help install the cap.

Genuine Makita replacement part. This is a long, narrow push-in rubber cap. It is tapered at one end and open at the other end.