Ryobi Tiller Hardware

This is an original replacement part sourced directly from the manufacturer. The screw is commonly found in yard equipment from Craftsman, such as lawn tractors, snow blowers, and edgers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You will require a wrench when replacing this item. The screw is sold as an individual replacement part.

This is a genuine OEM sourced replacement housing screw designed for Ryobi and Troy-Bilt trimmers and blowers. It is commonly utilized to secure the starter housing. Please note, this metal housing screw is sold individually. A torx screwdriver may be required to secure or remove it.

This silver metal lock washer helps prevent the nut on the drive belt pulley shaft from backing off during operation, it has a 5/16-inch inner diameter and a 1/2-inch outer diameter. one washer is included, replace it if fatigue or damage allows the connected shafts to spin freely, verify fit using the equipment model or owner manual

The Jamlock Nut is a 3/8-16 inch metal nut which can be installed using a socket or wrench set. It's used to secure and lock parts in place. If the part is damaged and comes loose it should be replaced. This is an authentic part authorized by the manufacturer.

This manufacturer-certified Hex Bolt, measuring 5/16-18 x .75 inch, is a gold, metal, individually sold bolt. It can be installed using a wrench or socket and torque wrench, by tightening to manufacturer specifications. If damaged (likely due to fatigue) the threads will be stripped, or the ends rounded off. If broken or missing, it should be replaced. Refer to your owners manual or model number to ensure you are purchasing the correct part.

This is an original Craftsman replacement part manufactured for use with paint sprayers, tillers, spreaders, and yard vacuums. The special knob is commonly used as a wing nut, and its application can vary depending on the model of equipment. This knob is available as an individual replacement part, please see model diagram for part location and usage.

This is an OEM part sourced directly from the manufacturer. The tap screw is designed for use in lawn mowers, lawn tractors, and tillers from MTD, Ryobi, and Yard Machines. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You may require an Allen wrench or hex key when replacing this part. This item is sold individually.