Router Power Cords

This cord is a genuine OEM replacement part and is sold individually. Power Cord Specifications: 2 Wires. 18 Gauge. 2 Prongs. 6-1/2 Feet Long. It is constructed with thick insulation for long service life and a strong two-prong plug. This cord is compatible with the tools listed below. It can work for other applications and for other tools as well, but compatibility is not guaranteed. Installation of this part requires the new cord wires be stripped and to fit correctly into the wire terminals.

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 2 Prongs • 2 Wires • 14 Gauge • 10 Feet Long

This cord is a genuine Makita replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Over time, power tool cords will wear out or become frayed. We recommend replacing a cord as soon as signs of wear are visible. Power Cord Specifications: • 2 Prongs • 2 Wires • 14 Gauge • 8 Feet Long

This cord is a genuine Porter Cable replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. rnPower Cord Specifications: rn • 3 Prongs rn • 3 Wires rn • 16 Gauge rn • 7 Feet Long

A tool that cuts out when its cord is moved may have a damaged power cord. Before replacing it, inspect the plug, outlet, extension cord, switch, motor brushes, and connections inside the tool. Confirm fit with the complete tool model because the wire ends and strain relief may differ. Unplug the tool and wait for it to stop fully. Mark each wire before disconnecting it, and never bypass the ground wire. Follow the original cord path, tighten the clamp, close the housing, and have the tool tested for electrical safety before use.

This twist lock cord is a genuine DeWalt replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Over time power cords can become damaged, frayed, or cut. Be sure to inspect the cord on a regular basis. We recommend replacing them at the first sign of wear or damage. Power Cord Specifications: • 3 Prongs • 16 Gauge • 10 Feet Long

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is an effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

This cord protector is a genuine Milwaukee replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.

This cord is a genuine Porter Cable replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 18 Gauge • 7 Feet Long • Porter Cable models: 6302 T4, 6902 T5, T6