Rolair Compressor Valves

Rolair Compressor Drain Valve This drain valve is an OEM direct from Rolair. Compatible with electric and gas compressors, the metal part is fitted at the base of the tank. This item allows the operator to drain the tank following each extended use. Regularly draining the tank prevents rust and leakage. The drain valve is sold individually. A wrench set may be necessary for the proper removal and installation.

Rolair Compressor Regulator This regulator is supplied directly from the original equipment manufacturer. Constructed of durable metal and plastic, this item is made for use with several air compressors. The regulator is fastened to the accessory bracket, allowing the operator to select the amount of air pressure for the tool in use. A wrench or pair of pliers may be required for the removal and installation. The regulator is sold individually. Please refer to manual for repair and safety instructions.

Rolair Compressor Valve (sold Individually) This valve is available as an individual replacement part even though many might be needed. It fits between the gasket and the valve plate. This part is a thin piece of metal and will need to be replaced if it breaks because it can cause air leaks. A wrench and a screwdriver may be needed during the replacement of this valve. It is a genuine Rolair replacement part that is sourced from the original manufacturer for use with compressors and pumps.

Rolair Compressor Valve This is a genuine OEM sourced part used on several compressors. The metal valve is fitted onto the valve plate, providing a way for gas to properly circulate through the cylinder. You will need a wrench to complete this repair. This item is sold individually. It is also recommended to refer to the manual for further safety and repair instructions.

Rolair Compressor Check Valve, Female X Male 200 Safety Valve Included

Rolair Compressor Safety Valve It is a genuine item that is supplied directly from the original equipment manufacturer for use with Rolair compressors. The safety valve is designed to keep the tank from over-pressurizing, unfortunately, over time it may wear out or get damaged eventually requiring a replacement. Keep in mind this high-quality part is made of durable metal and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component.

Rolair Compressor Regulator

Rolair Compressor Bleeder Valve This bleeder valve is a genuine OEM sourced part that is specially designed for use with Rolair air compressors. The bleeder valve allows some air to escape until the air in the tank reaches a certain level. Unfortunately, over time components may wear out or get damaged eventually requiring a replacement. Please note, this high-quality component is sold individually. A wrench will be needed to perform this repair. Make sure to drain the air from the tank and unplug the equipment from the power source before starting this repair.

Rolair Compressor Regulator This is a genuine OEM part. The Rolair regulator is made for use with the FC2002 Hand Carry Compressor. This important component regulates the air compressor pressure, and is sold individually. You will need a wrench set to install the durable, metal and plastic regulator.

Rolair Compressor Check Valve, Tank 1/2 It is an authentic item that is supplied directly from the original equipment manufacturer for use with Rolair compressors. The check valve lets pressurized air flow into the tank and prevents it from flowing back into the pump. When replacing this part make sure to unplug the air compressor and release the air from the tank. Unfortunately, over time it may wear out, get damaged or simply lost eventually requiring a replacement. Please make sure to check the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality valve is sold individually.