Pressure Washer Handles

This authentic OEM trigger handle is specially designed for use with pressure washers. It allows the user to control the pressure and flow of water during use. It has an ergonomically designed grip allowing for easy and longer handling. When the pull lever/trigger mechanism is squeezed, it activates the pump, and pressurized water is released through the nozzle. However, if the trigger handle is loose or damaged you will notice water leakage, loss of pressure, weak flow, or no flow at all. A damaged trigger may also cause water to flow continuously leading to wastage and potential safety hazards. Turn off the water supply, and disconnect the washer from power before beginning this repair. Remove the trigger handle from the holder at the end of the pressure washer wand and check the area for any clogs or damage. Place the new handle onto the holder and ensure it is securely fitted before restoring the water supply.

This is a genuine manufacturer approved replacement part designed for use with pressure washers. It is the essential part of the unit allowing to direct and control the spray. This pistol assembly is made out of plastic and metal. It is sold individually. Please note the wand is sold separately.

This is an authentic Ryobi replacement part, sourced from the original manufacturer for use with pressure washers. The special trigger handle holder is used to mount the trigger handle to the frame. This trigger handle holder assembly is available as an individual replacement part.

This part is the OEM part from Craftsman for pressure washers. This part releases a stream of water when you push on the trigger. You might need an adjustable wrench to replace this part. This part is made of durable plastic and sold individually.