Pipe Tools Hardware

Pipe Tools Feed Screw Assembly

Pipe Tools #10-24 Screw This is a genuine manufacturer-sourced part which is designed for use with Ridgid combo roll groovesr. These are special screws utilized to secure the <a href="http://www.ereplacementparts.com/cover-plate-p-211707.html" target=blank><u>#93312 Cover Plate</u></a> which is sold separately. Please make sure to refer to the owners manual and the appropriate diagrams of your model for the correct location and application of these components. Keep in mind this high-quality screw is made of durable metal and is sold in a pack of four.

Pipe Tools Shoulder Bolt This replacement shoulder bolt is supplied from original equipment manufacturer for use with Ridgid pipe and bolt threading machines. It is used to secure the lever arm assembly to the carriage unit. It is a hex head bolt and it is sold individually. You would need a wrench to install it.

Pipe Tools Thrust Washer The thrust washer goes between the clamp lever and the throw-out lever. This item is available as an individual replacement part. It is an OEM from Ridgid for use in die heads. When replacing this part an allen wrench and a set of pliers might be required during the installation process. This part is made out of metal and will need to be replaced if it breaks.

Pipe Tools Retaining Ring

Pipe Tools E Clip This item is an authentic Milwaukee replacement part that has been sourced from the original manufacturer to be used with copper tubing cutters. The e-clip is intended to be used to secure a part assembly along a shaft or pin. This part is priced as a single item.

Pipe Tools E Clip

Pipe Tools E Clip This is an authentic OEM part. The Milwaukee e clip is made of durable metal, and is designed for use with several copper tubing cutters. This item secures the idler gear in the handle set. The e clip is sold individually. A screwdriver is necessary in making the replacement.

Pipe Tools Lever Washer This is a genuine OEM part. The Ridge Tool Company lever washer is constructed of durable metal, and is compatible with various die head and threader tools. This part has been designed to secure the clamp lever to the head w/post & latch assembly. A wrench may be needed in making the repair. This item is sold individually.

Pipe Tools Nut Locking Pin It is an authentic OEM part that is specially made for use with Ridgid vises. The nut locks the swivel nut in the base assembly. It is an identical replacement for a faulty or a missing hardware that was installed on a new unit. This high-quality component is made of durable metal and is sold as an individual item. Make sure to refer to the appropriate diagrams for your model to ensure the exact location and the correct application.