Nailer Hardware

This special grommet is an original part which is specially designed for use with DeWALT and Porter Cable staplers and nailers. It is utilized to secure the pin that holds the adjuster. This is a high-quality replacement for a damaged or a missing grommet that was installed on a new unit. To ensure the correct location and application of this part, refer to the appropriate diagrams of your model. It is made of durable rubber and is sold individually. You may need pliers to remove and secure the grommet with the pin.

This is an authentic OEM product which is designed for Bostitch, DeWALT and Porter Cable nailers and staplers. It provides a tight seal for the valve piston. Over time the material may wear down causing air leaks. To replace this flat washer you will need a screwdriver and pliers. This item is sold individually and is made of durable material. Check the diagrams of your model for the proper installation.

Genuine Porter Cable replacement part, this item is sold individually. This retaining Ring is used in various areas of the Pneumatic Tools listed below. In most cases it is used to secure a pin in place in the tool.

This genuine Makita replacement part is designed for use with a variety of power tools. This screw is a standard hardware which has multiple applications based on your tool. It is made out of metal and it is sold individually. Would require a screwdriver to install or remove this screw.

Help keep your tool operating reliably with this pin assembly, an important component that attaches to the piston and helps secure the driver in place during operation. Made from durable metal, it supports proper alignment of the driving mechanism for consistent fastening performance. Replacing a worn, damaged, or missing pin assembly can help restore smooth tool function and maintain dependable operation. Because component placement may vary between models, refer to your tool's parts diagram or service manual to confirm the correct installation location before assembly. Installation typically requires removing the existing pin assembly using a hex key and securing the replacement component in place.

Genuine Porter Cable replacement part, this item is sold individually. This part acts as a seal and a spacing collar for the Nail Guns. This is a neoprene part and it has a tendency to deteriorate. It may be a good idea to check on the condition of this part periodically.

This is a genuine item that is supplied by the original equipment manufacturer for use with Ridgid nailers. It is a special component that is utilized to provide a tight seal for the valve, unfortunately, over time the material will wear out and it may begin to fail eventually requiring a replacement. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable rubber and is sold individually.

This is a genuine OEM sourced replacement part designed for use with a variety of power tools. This is a standard hardware which has multiple applications based on your tool. For proper use please refer to diagrams. This is a metal torx T20 metal screw which is sold individually.

It is a genuine item is supplied by the original equipment manufacturer for use with Bostitch staplers. The pin helps to secure the magazine assembly to the frame grip-pad assembly. It is an identical replacement for a missing or a faulty pin-pivot that was installed on a new unit. Please make sure to check the diagram of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable metal and is sold individually.

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.