This a genuine OEM microwave cooking tray. It is also known as a microwave turntable or microwave plate. The function of the tray is to hold and rotate food items while the appliance is in use to ensu...
If the microwave exhaust fan is not circulating air properly, there could be an issue with the grease filter. A dirty filter will cause your microwave to run less efficiently and can alter the taste o...
This is a package of 2 filters. The charcoal filter is used in microwaves to remove food odors from the air. If your filter is damaged or strong odors are coming from your microwave, it is best to rep...
The vent grille mounts to the top of the microwave, above the door. If you notice that your vent grille is damaged, or your door is not closing properly, you may need to replace the vent grille. This ...
This surface light bulb is used in ranges and microwaves. It has a high voltage of 12 and 10 watts. This bulb illuminates and directs light at the bottom of the microwave or the inside of it. It also ...
This turntable ring in your microwave makes sure that your glass tray rotates smoothly. Located just above the internal floor, it supports the tray so that your food cooks evenly. A broken turntable r...
This diode, or high voltage diode, is used in microwaves. It is an electrical current control device that ensures power flows in one direction and not the other way. If your microwave produces no heat...
Slide grease filter about 1/2 inch to right (or left) using the d-ring attached to one side and then pull down and out. Push charcoal filter frame slightly to rear and pry down from front. Install new charcoal and grease filters by reversing process. No tools - 5-minutes max!!
First -- and this was the key to success -- I watched a couple of Youtube videos on "Replacing a microwave door handle". As one video suggested, I placed a large towel underneath where I was working (over the stovetop) to catch any falling parts but this proved unnecessary. Once I removed the two screws from the end of the door, the ins
... Read moreide of the door pried off easily with a screwdriver. It did want to drop quickly though, so be ready to hang onto it. The handle was attached with two screws (which I reused, no problem). It took a few minutes to re-insert the inside of the door into the frame, but once that's done, you just re-install the two end screws and you're finished.