XT800-3058 Kohler Engine - Overview

This is an authentic Kohler replacement part that is manufactured for use with small engines. The stud is used to support the housing for the starter recoil assembly. These studs are sold as individual replacement parts.

The diaphragm attaches to the screw shoulder and is made of plastic and metal. This part is available as an individual replacement. This genuine item is supplied by the original equipment manufacturer for use with Kohler engines and Husqvarna lawn mowers. During replacement, it may require a set of pliers, a socket set, a wrench set, and ...Read morea torx driver to help install this part correctly. It will require replacing if it breaks.

This replacement starter assembly is an authentic OEM sourced item that is specially designed for Kohler engines. This is the starter assembly that is used to pull-start the engine. It includes a plastic shroud, starter pulley, starter spring and the pull rope with a grip handle. Please note the hardware to secure this assembly is sold separately. To complete this repair you would need a wrench.

This genuine OEM part is designed for use with Kohler engines commonly installed on a variety of lawn and garden equipment. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a ...Read moreteaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts and then quickly dies, the carburetor is likely the problem. To complete this repair you would need a screwdriver and a wrench set. Note, the kit includes one durable metal body carburetor and two gaskets to ensure a tight fit.

This is a genuine manufacturer-supplied tube assembly oil fill that is specially made for use with Kohler engines that are commonly installed on a variety of lawn and garden equipment. It is utilized to refill the oil in the cylinder assembly and to hold the dipstick for checking the oil level. It is a high-quality replacement for a damag...Read moreed or a missing part that was installed on a new unit. Check the diagrams for your model to ensure the proper repair procedure. Note, it is made of durable plastic and is sold as an individual item.

This is an authentic part from Kohler for use in engines. The oil seal fits between the flat washer and the clip governor shaft. If this item becomes broken it will need to be replaced and may require a set of pliers during the installation. This is available as an individual replacement part and is made of plastic and rubber.

This is an authentic manufacturer-sourced component that is specially manufactured for use with Kohler engines commonly installed on lawn and garden equipment. The stud is utilized to support the housing for the starter recoil assembly, please make sure to refer to the appropriate diagrams of your model for the correct location and applic...Read moreation of this part. Keep in mind this high-quality hardware is made of durable metal and is sold individually.