XT149-0315 Kohler Engine - Overview

This is an authentic Kohler replacement part that is manufactured for use with small engines. The stud is used to support the housing for the starter recoil assembly. These studs are sold as individual replacement parts.

This is an original replacement part manufactured for use with Kohler small engines. The flanged hex nut is typically used as a fastener on the governor control assembly. This nut can have multiple uses, please see model diagram for part location and usage. The flanged nut is available as an individual replacement part.

This is an authentic replacement part manufactured for use with Kohler small engines. The ignition module creates and electric charges as the magnet on the flywheel passes, the charge is sent to the spark plug to ignite the air/fuel mix in the combustion chamber. A faulty ignition module will likely prohibit the engine from starting while...Read more the motor maintains compression. This ignition module is available as an individual replacement part.

This is a genuine replacement part sourced directly from the manufacturer. The fuel hose is commonly found in Kohler engines. This part is made of flexible rubber, and is used to carry fuel. You may require pliers when replacing this item. The fuel hose is sold as an individual replacement part.

This is a genuine manufacturer-supplied tube assembly oil fill that is specially made for use with Kohler engines that are commonly installed on a variety of lawn and garden equipment. It is utilized to refill the oil in the cylinder assembly and to hold the dipstick for checking the oil level. It is a high-quality replacement for a damag...Read moreed or a missing part that was installed on a new unit. Check the diagrams for your model to ensure the proper repair procedure. Note, it is made of durable plastic and is sold as an individual item.

This is an authentic Kohler replacement part. The oil pan gasket is designed by the manufacturer for use in engines. This part is made of flexible plastic, and is used to seal the connection with the oil pan. You will require a wrench when replacing this part. This item is sold individually.

This is an authentic part from Kohler for use in engines. The oil seal fits between the flat washer and the clip governor shaft. If this item becomes broken it will need to be replaced and may require a set of pliers during the installation. This is available as an individual replacement part and is made of plastic and rubber.

This is an authentic manufacturer-sourced component that is specially manufactured for use with Kohler engines commonly installed on lawn and garden equipment. The stud is utilized to support the housing for the starter recoil assembly, please make sure to refer to the appropriate diagrams of your model for the correct location and applic...Read moreation of this part. Keep in mind this high-quality hardware is made of durable metal and is sold individually.