XAG20Z Makita Grinder - Overview

This tapping screw is an authentic hardware that is supplied by original tool manufacturer for use with a variety of Makita power tools. It has multiple uses depending on the model of your unit, please make sure to check appropriate diagrams for correct location and use of this screw. Note this durable metal screw is sold individually.

This is a genuine Makita replacement part, it is sold individually. Its purpose is to drive the 227505-7 Main Gear. This part is replaced by sliding it on the fan end armature shaft, then securing it to the shaft with the 252186-8 nut. Once you have the Gear Housing apart, this is a good time to make sure the Main Gear has no wear, also check the bearings to make sure they are in good working order.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Makita power tools. It is an identical replacement for a missing or damaged rubber pin that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and applicat...Read moreion of this hardware. Keep in mind this high-quality item is made of durable rubber material and is sold individually.

This Ball Bearing is shielded on both sides. It is a genuine Makita replacement part and is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on ...Read morethe tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

Genuine Makita replacement part, this item is sold individually. The Pin Cap is part of the spindle lock assembly for the Makita Tool model numbers shown below. When it is pressed it will stop the spindle from rotating, so that a grinding wheel or blade can be removed or installed.

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it has multiple applications based on your tool. Please refer to diagrams for correct application.

This is a genuine Makita replacement part that has been sourced from the original manufacturer to be used with angle grinders and die grinders. The o-ring is commonly used to seat and support the drive gear bearing assembly. This item is sold as an individual replacement part.

This is an authentic manufacturer-sourced replacement part which is specially designed for use with Makita grinders. It helps to provide an air-tight seal for the bearing box, over time it may wear out and begin to crack eventually requiring a replacement. It is made of high-quality rubber and is sold individually.

This O-ring creates a tight seal within the spindle lock assembly, helping prevent oil leaks while keeping dust and debris out of the gearbox. Made from durable rubber and measuring approximately 0.25 × 0.25 × 0.25 inches, it supports reliable protection and long-lasting performance. Replacing a worn or damaged O-ring helps maintain proper sealing, protect internal components, and ensure smooth tool operation.

This is an authentic OEM approved replacement item commonly used on Makita power tools. Bearings have many useful applications that will differ depending on a tool. Ball bearings are designed to minimize friction between two rotating parts. Because they are under constant pressure. Over time due to heat and friction bearings would break d...Read moreown and would need to be replaced. Please note this is a sealed metal bearing that is sold individually.