WT06Z Makita Wrench - Overview

This replacement clip is an authentic OEM component which is made for Makita impact wrenches. The part is secured in the anvil and it helps to apply tension on the socket to secure it. Over time it may wear out and lose tension eventually requiring a replacement. If a socket does not stay put on the anvil, a faulty or a damaged clip may b...Read moree the cause. Make sure to refer to the appropriate diagrams of your model for the exact location and the correct installation of this clip. One durable metal item is included. You will need pliers to remove the old one and secure the new one in the anvil.

This authentic Makita replacement part is designed for use with impact wrenches. This pin fits in the anvil and it helps to hold sockets in place. This part is made out of metal and it is sold individually. To complete this repair you would need a screwdriver and pliers.

This genuine OEM steel ball is found within the housing of your power tool. It serves as a detent mechanism, securing the shift knob in various positions to allow for the selection of different operating modes. It has a diameter of 4.8mm. If you notice signs of wear or deformation on the steel ball, it is a clear indication that it needs ...Read moreto be replaced. A worn-out steel ball can result in a loose shift knob that fails to hold its selected position properly. To locate and access the steel ball within the housing, refer to the instructions outlined in your user manual. Your tool may use steel balls of different sizes, so confirm that this is the correct part your repair will need before making your purchase.

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it has multiple applications based on your tool. Please refer to diagrams for correct application.

This f/r change lever is supplied directly from the original equipment manufacturer. Compatible with the Makita XST01 18V LXT Cordless 3-Speed Impact Driver, this item is sold individually. The plastic lever is fitted in the housing set, above the switch, allowing the operator to change the direction of the drill bit. A screwdriver is necessary for the removal and replacement.

This replacement tapping screw is sourced directly from original equipment manufacturer. It is specially designed for Makita power tools. It is a standard hardware which has multiple applications based on a tool. Please make sure to check appropriate diagrams for the location and use of this screw. This part is made out of metal and it is...Read more sold individually. Requires a screwdriver to tighten/loosen this screw. This is a self tapping screw can tap its own hole as it is driven into the material.

This is an OEM part sourced directly from the manufacturer. The o-ring is used in Makita demolition hammers and multi-tools. An o-ring is a plastic part designed to seal and pad the connection between two other parts, and there may be many different sizes of o-ring in the same tool. Please refer to the parts diagram to be sure you're o...Read morerdering the correct part. You may require a screwdriver or wrench to replace this part. It is advisable when removing parts to keep careful track of the order they should be in, so they can be replaced correctly. This part is sold individually.