WT05R1 Makita Wrench - Overview

This genuine OEM steel ball is found within the housing of your power tool. It serves as a detent mechanism, securing the shift knob in various positions to allow for the selection of different operating modes. It has a diameter of 4.8mm. If you notice signs of wear or deformation on the steel ball, it is a clear indication that it needs ...Read moreto be replaced. A worn-out steel ball can result in a loose shift knob that fails to hold its selected position properly. To locate and access the steel ball within the housing, refer to the instructions outlined in your user manual. Your tool may use steel balls of different sizes, so confirm that this is the correct part your repair will need before making your purchase.

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it has multiple applications based on your tool. Please refer to diagrams for correct application.

This O-ring creates a tight seal within the spindle lock assembly, helping prevent oil leaks while keeping dust and debris out of the gearbox. Made from durable rubber and measuring approximately 0.25 × 0.25 × 0.25 inches, it supports reliable protection and long-lasting performance. Replacing a worn or damaged O-ring helps maintain proper sealing, protect internal components, and ensure smooth tool operation.

This f/r change lever is supplied directly from the original equipment manufacturer. Compatible with the Makita XST01 18V LXT Cordless 3-Speed Impact Driver, this item is sold individually. The plastic lever is fitted in the housing set, above the switch, allowing the operator to change the direction of the drill bit. A screwdriver is necessary for the removal and replacement.

This replacement tapping screw is sourced directly from original equipment manufacturer. It is specially designed for Makita power tools. It is a standard hardware which has multiple applications based on a tool. Please make sure to check appropriate diagrams for the location and use of this screw. This part is made out of metal and it is...Read more sold individually. Requires a screwdriver to tighten/loosen this screw. This is a self tapping screw can tap its own hole as it is driven into the material.

This is an OEM part sourced directly from the manufacturer. The o-ring is used in Makita demolition hammers and multi-tools. An o-ring is a plastic part designed to seal and pad the connection between two other parts, and there may be many different sizes of o-ring in the same tool. Please refer to the parts diagram to be sure you're o...Read morerdering the correct part. You may require a screwdriver or wrench to replace this part. It is advisable when removing parts to keep careful track of the order they should be in, so they can be replaced correctly. This part is sold individually.