WT-279-1 Walbro Engine - Overview

A diaphragm carburetor depends on flexible pump and metering pieces to move and control fuel. When those pieces harden, a small two-cycle engine may become difficult to start, surge, lose power, idle poorly, or leak fuel. A rebuild set can renew the worn internal seals, screen, needle, and lever parts. These carburetors use a metering cha...Read morember, not a float bowl, so the needle controls fuel entering that chamber. Confirm the stamped carburetor code before ordering. During service, note diaphragm and gasket positions, clean passages without enlarging them, and set the metering lever only to the service specification. Keep fuel away from sparks and test for leaks before use.

This is a Genuine OEM rebuild kit designed for Walbro Carburetors. This kit contains all the necessary Gaskets and Diaphragms needed to rebuild your carburetor. If your engine runs sluggish or it dies shortly after starting it, you may need to rebuild your carburetor. Replacing these items you would need a Screwdriver and Pliers.

This is a genuine item that is supplied by the original equipment manufacturer for use with Walbro carburetors. It is an identical replacement for missing or a faulty plug-welch that was installed on a new unit, please make sure to refer the appropriate diagrams of your model for the correct location and application of this hardware. Keep...Read more in mind this high-quality part is made of durable material and is sold individually.

This is an authentic Walbro replacement part, sourced from the original manufacturer for use with carburetors. The special throttle shaft ring is commonly used to secure the throttle shaft. This ring is available as an individual replacement part, please see model diagram for associative parts.