This water filter (Whirlpool EveryDrop Refrigerator Water Filter, Single Turn Filter) purifies water going to the water dispenser and sometimes the icemaker as well. This part should be replaced if it...
Sold individually. This door bin is for refrigerators.
Door bin attaches to the inside of the refrigerator door and typically holds jars and bottles.
Follow the instructions in the owner's manua...
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
This light switch may also be known as a refrigerator door switch or a light switch kit, and is compatible with your refrigerator. The function of the refrigerator door switch is to turn on the light ...
The p-trap drain tube kit may also be known as the duck bill, or the drain pipe, and it is compatible with your refrigerator. The function of the p-trap drain kit is to carry the water that has formed...
This is a light switch for your refrigerator. It activates when the door of your appliance is opened, and it will turn the light inside on and off. You will need to replace this part is if your light ...
This bin can be moved according to space needed. It holds items on the door of your refrigerator. They are sometimes called Cantilever Shelves as they are supported by the back of the door of your ref...
This mounting screw is a genuine OEM replacement part for the door handle in your refrigerator. If you are having trouble shutting the refrigerator door, or opening it, replacing this screw can help s...
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
JJ
July 15, 2021
My freezer keeps thawing and refreezing every few weeks. I constantly have to clean out the ice that builds up on the bottom. Sometimes I can see the seal on the door is not closing all the way but then after I get it to stop doing that(usually after about 2-3weeks) it seems fine. Then after another few weeks it starts doing this again.
For model number WRX735SDBM00
Hello JJ, Thank you for the question. If the gasket is not sealing it will allow warm air in and cause issues with the Defrost Cycle. We hope this helps!
Do you sell the front door gaskets? If yes how much do they cost.
For model number WRX735SDBM00
Hi Marie,
Thank you for your question. The part number listed under your model number for the refrigerator door gasket is PS11759518. The part number for the bottom freezer door gasket is PS11754809. If you would like to place an order for them, you may order them either online or by calling our customer service line and anyone will be happy to assist you. We hope this helps! If you have any questions, please let us know.
Hello Doc,
Thank you for your question. It sounds like either the filter cover under part PS11743682 is damaged where it connects to the bracket tabs, or the bracket itself under part PS2069868 is damaged and would need to be replaced. We hope this helps!
Where is the air filter located .?
ice taste bad, cleaned and replace water filter in fridge.
For model number WRX735SDBM00
Hello, Thank you for your question. There is actually not an air filter for your model. You will need to check with the manufacturer and see if they offer a universal one. We hope this helps.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Bruce
December 23, 2021
Water does not seem to be making it to the ice maker. I do have water dispensing through the normal method. I have checked the options and the ice maker is on. I need help.
For model number WRX735SDBM00
Hello Bruce, Thank you for the question. We suggest to check the water lines to the ice maker to make sure the lines have not froze over and is blocking the water from getting to the Ice Maker. Next, replace the Water Filter if it is over 6 months old. It can effect the water Pressure and the water will not be able to make it to the Ice maker. If the Filter is under 6 months, you can test the Valve. It has two ports, one for the Ice Maker and one for the Dispenser. Set your multitester to the R X 1 ohms setting to test for continuity. Place each of the multitester's leads on a terminal. Your multitester should display a reading between 200 and 500 ohms. Closely examine your water inlet valve. The exact ohm resistance rating you should test for may be marked on the valve. We hope this helps!
Pressed in the end of the filter cover, lowered it down part way. Twisted the old filter 1/4 turn and removed it. Set in the sink to drain. Inserted new filter and twisted it to lock. closed cover. Done. Total time @ 1 Minute.
I removed the drop-down outer housing by gently prying the sides of the two pivot pins at the rear. This gave me move 'room' to grip and slightly rotate then pull the old filter forward and away from the tight suction connection. I was concerned that I would be too forceful for the plastic assemblies and would break something; deliberate motions and a steady thought process on the problem helped disengage the darned old filter!
With our Fix app model plate image recognition technology, we'll recommend the parts guaranteed to fit your appliance. Simply snap a photo, and we'll take care of the rest.
"I love love love this app. It's so nice to have useful information (receipts, manuals, parts lists, warranty info, pictures, etc.) on all of my household appliances and devices in one place."
You added to your cart
✖
$
Qty:
Total item(s) in cart:
Order Subtotal
$
*Taxes and shipping will be applied during checkout
Douglas from Byron, NY
Difficulty Level:Really Easy
Total Repair Time:Less than 15 mins
