This capacitor (Refrigerator and Freezer Compressor Run Capacitor, Run Capacitor) provides the voltage or energy current required to start the compressor and keep it running. It allows the compressor ...
This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.
This touch-up paint can be used on a wide variety of household appliances. It is most often used on washers, dryer, refrigerators, dishwashers, ranges, freezers, trash compactors, or microwaves. It is...
This hinge bracket, also known as a door stop, is attached to the bottom of the door and is used to limit how far the door swings out to protect the refrigerator itself, and any surrounding cabinets f...
This clear plastic door bin attaches to the inside of the refrigerator door and holds jars and bottles. Door bins can crack and break due to frequent and heavy use, and faulty bins should be replaced.
This is a genuine Whirlpool replacement part. This drawer hanger is for refrigerators and its job is to support the drawer. It is approximately 11 inches in length, and is made of plastic.
This track is a genuine OEM replacement part for your refrigerator. It is made of white plastic. The track supports the shelf within your fridge, and can be snapped in and out of place, which makes re...
The light socket in your refrigerator houses the light bulb and connects it to the power source. If your refrigerator light is not coming on when you open the door, you may need to replace the light s...
$70.72
In Stock
Questions And Answers for WRT3L1SZYB00
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Glenda
January 29, 2023
REPLACE ICEMAKER
For model number WRT3L1SZYB00
Hello Glenda, Thank you for your inquiry. Researching the model number that you have provided, we show that this model uses an add on ice maker kit, part# PS11757273. To install this part, first unplug the refrigerator and open the freezer door and remove the old ice bucket if applicable using a quarter inch socket or nut driver, fully unthread the lower screw securing the ice maker to the liner. Loosen the two upper screws with the screws loosened you can lift the icemaker off of the screws lift the tabs to disconnect the wire harness to fully remove the old icemaker. Prepare the new ice maker for installation by transferring the wire
harness from the old unit to the new one, you will need to detach the module cover to release the wire. With the wire attached, snap on the module cover and returning to the freezer compartment, connect the wire harness and align the ice maker on the fill tube as you hook the brackets on the upper screws. Tighten the screws and place the ice bucket back into place. Plug the power cord back in and your refrigerator ice maker should be ready for use. Good luck with the repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Brandon
September 9, 2021
I replace my evaporator fan in my freezer and replaced the thermostat that runs inside the fridge part of my refrigerator i also replace the relay switch near the compressor and my fridge still isn't freezing my water is it defrost timer or is it the damper if my fridge has a damper cuz i cannot locate it
For model number WRT3L1SZYB00
Hello Brandon, Thank you for your inquiry. The damper in your model would be the air tower and air diffuser, and you can test the defrost thermostat with a multimeter to see if it is causing the issue. Good luck with your repair.
I knew the chances of all the freon leaking out was unlikely so I looked at the wiring to the compressor and there was a capacitor and a starter/overload so i figured I would start there. I went on line and found the parts at this site and they were less than the minimum service call charge for a service tech so I figured what the heck le
... Read moret's give her a shot so I did give it a shot. I ordered the parts and they were there in less time than a service tech could come out and i installed the parts and guess what for 90.00 in parts and 15 minutes in time I repaired my refrigerator. Thanks guys, It took less time to order the parts than it did to make the repair so thanks, your website rocks and is very well designed so my hat is off to you guys!
The reason I repaired it myself was because the repairman that diagnosed the problem.didn't come back in two weeks. The evaporator fan sits behind a vented wall in the freezer and directs cold air into freezer and refrigerator.I removed the ice make assembly first and then the freezer wall held in place by two sheet metal nuts. Then remov
... Read moreed wires from fan motor. Removed the fan blade from fan motor,which was press fitted on,then removed fan motor from bracket assembly(make sure and retain the two vibration rubber washers on back and front of motor. Reinstall new motor with vibration washers and press fan blade on new motor. Install in bracket assemble and reassemnble.
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again.
