This capacitor (Refrigerator and Freezer Compressor Run Capacitor, Run Capacitor) provides the voltage or energy current required to start the compressor and keep it running. It allows the compressor in your appliance to easily cycle on and off. This capacitor mounts directly onto the compressor starting relay. If the capacitor is faulty ...Read morethe compressor may get unusually hot and draw excessive amperage. It the compressor overheats, it may fail to run until it cools down again. The compressor may also get noisy from overheating. If this part is totally electrically open, it is defective (often due to overheating) and needs to be replaced. The part measures 1 inch by 1-1/2 inches, and is constructed of plastic with two metal wire terminals. This item includes 1 capacitor, sold individually. This part comes in black.
This is a meat drawer shelf frame for some models of refrigerator. This white plastic frame measures approximately 15 inches wide by 11.5 inches deep by 1.5 inches tall, and is used to allow the meat drawer to easily slide in and out of the fridge. If your meat drawer is currently sagging and this frame is damaged and not supporting it en...Read moreough, it needs to be replaced. Replacing this frame requires you to remove the meat drawer and the glass shelf above it, so you can flip it over and slide out the old frame, and slide in the new. This frame is supplied by the original equipment manufacturer and is sold individually, so it does not include any other parts for the meat drawer or shelf above it.
This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.
This door shelf bin is a genuine OEM replacement part that is designed for refrigerators. It is made of clear plastic and fits on to mounting brackets on the the interior of the door. The door shelf bin is a storage compartment that allows users to easily hold and organize various food items and containers. It provides a convenient way to...Read more maximize the amount of storage space inside the refrigerator. Over time, the door shelf bin may crack, break, or become discolored or warped. You should replace the bin if it can no longer safely hold the items placed in it. No mounting hardware is necessary for this repair, simply detach the old bin from the fridge door and mount the new one in its place.
This touch-up paint can be used on a wide variety of household appliances. It is most often used on washers, dryer, refrigerators, dishwashers, ranges, freezers, trash compactors, or microwaves. It is an 18 ml, or.6 fluid ounces, bottle of touch-up paint. It also features a brush for easy application. This quick-drying, long-lasting paint...Read more is perfect for fixing any nicks, scratches, or chips on the exterior of your appliance. This paint is white in color, and provides a durable finish.
This hinge bracket, also known as a door stop, is attached to the bottom of the door and is used to limit how far the door swings out to protect the refrigerator itself, and any surrounding cabinets from potential damage. If your fridge is having issues opening or staying closed, check the hinges for any damage or cracking. To replace thi...Read mores bracket, simply remove the door off your refrigerator, unscrew and remove this bracket from the bottom of the door, and install the new one. This hinge bracket is an OEM replacement and is compatible with several different makes and models of refrigerator.
Ask our experts a question about this model and we'll get back to you as soon as possible!
We may have answered a similar question already! Search questions and answers left by others using simple keywords like "fit", "broken", "easy", or "quality" to find questions that match.
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Sort by:
Prev
1
2
3
Next
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Jim - For model number WRT311FZDW00
January 30, 2020
What currently available ice maker fits this model?
Hello, Thank you for contacting us. I have researched the model you have provided and have found the part you’re looking for is Ice Maker Assembly (Part# PS11757273).
My refrigerator is blowing water inside the refrigerator. Water as well as air is conning out of vents. What is wrong
Hello Steve, thank you for your question. Your symptoms point toward a frozen defrost drain tube in the freezer. During the automatic defrost cycle, condensate melted off of the evaporator coils drips down into the drain pan. This water should drain down to a collection pan at the bottom of the refrigerator. Since it is frozen or clogged, the water is leaking into the refrigerator. If you do not feel confident in removing the rear freezer panel and defrosting/clearing the drain path, we recommend calling a service technician to correct this problem. If you are able to complete this procedure, you may be able to correct the problem yourself: Unplug the refrigerator to disconnect electrical power.
Remove all items out of the freezer and pull out the bottom floor. Remove the screws that hold the icemaker to the side wall in the freezer. Disconnect the wire harness plug and pull the icemaker out of the freezer compartment. Remove the screws that secure the back panel in the freezer and carefully pull it out. CAUTION: Internal metal edges can be sharp. Protective gloves are recommended. With the back freezer panel removed, you should be able to defrost and clear the defrost drain tube. After clearing out any ice, you may pour hot water down the drain to make sure the it is completely clear. Reassemble the freezer and monitor the performance. This procedure may correct your problem if the drain is properly cleared and stays clear. Use a hair dryer to defrost the frozen drain pan. We hope this helps.
5 peoplefound this instruction helpful.
Was this helpful?
Thank you for voting!
Larry - For model number WRT311FZDW00
July 20, 2021
My freezer keeps freezing up and the fan stops I have replaced the fan twice but still have the problem
Hello Larry, Thank you for the question. This could be an issue with the Defrost Cycle not properly defrosting and causing the build up on the fan. We suggest testing the Defrost Thermostat, PartSelect Number PS11754118. The best way to do this is to remove the thermostat from the refrigerator so you can control the temperature of the sensor. You can let the sensor warm up to room temperature. With the sensor warmed up to room temperature the sensor should read approximately 6.2K Ohms at 68°F. With the thermistor submerged is a glass full of ice water, the sensor should be very close to 32°F which should read approximately 16.3K Ohms. If the values that you are getting are far off from these readings, then the sensor is bad and should be replaced. We hope this helps!
What is the part number for the rear roller? Thank you.
Hello Donna, Thank you for contacting us. We have researched the model you have provided and have found the part you are looking for is PartSelect Number PS11755335. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!
Hello Bruce, thank you for your question. The compatible cantilever bin for your model is part number PS11703474. They can be used to hold beverages. If you need help placing an order, customer service is open 7 days a week!
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
My refrigerator stopped cooling and the freezer section stopped freezing
441 of 556 peoplefound this instruction helpful.
garth from forest lake, MN
Really Easy
15 - 30 mins
Nutdriver, Screw drivers
I knew the chances of all the freon leaking out was unlikely so I looked at the wiring to the compressor and there was a capacitor and a starter/overload so i figured I would start there. I went on line and found the parts at this site and they were less than the minimum service call charge for a service tech so I figured what the heck le
... Read moret's give her a shot so I did give it a shot. I ordered the parts and they were there in less time than a service tech could come out and i installed the parts and guess what for 90.00 in parts and 15 minutes in time I repaired my refrigerator. Thanks guys, It took less time to order the parts than it did to make the repair so thanks, your website rocks and is very well designed so my hat is off to you guys!
Read less
Was this helpful?
Thank you for voting!
Evaporator Fan failure
164 of 190 peoplefound this instruction helpful.
William from Middletown, NY
Easy
15 - 30 mins
Nutdriver
The reason I repaired it myself was because the repairman that diagnosed the problem.didn't come back in two weeks. The evaporator fan sits behind a vented wall in the freezer and directs cold air into freezer and refrigerator.I removed the ice make assembly first and then the freezer wall held in place by two sheet metal nuts. Then remov
... Read moreed wires from fan motor. Removed the fan blade from fan motor,which was press fitted on,then removed fan motor from bracket assembly(make sure and retain the two vibration rubber washers on back and front of motor. Reinstall new motor with vibration washers and press fan blade on new motor. Install in bracket assemble and reassemnble.
Read less
Was this helpful?
Thank you for voting!
Lights inside refrigerator not working
137 of 257 peoplefound this instruction helpful.
Clint from Rayville, MO
Really Easy
Less than 15 mins
Screw drivers
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again.
My Orders
