WL660800 Campbell Hausfeld Compressor - Overview

Designed for use in compressors, this genuine replacement part is used to provide a seal and prevent leaks. It is red, made of rubber, is not part of a kit or assembly, and is sold individually. When this part is worn, you will notice leaks from your machine, and it will need to be replaced. As with most rubber seals, this part is known...Read more to wear with regular use of your compressor, and will no longer be able to properly seal when it needs to be replaced. It is found at the bottom of the air tank, and you will need a wrench to complete this repair. Customers rate this repair as Easy.

The purpose of a gauge is to register the pressure readings inside the tank. This replacement gauge is sourced directly from original equipment manufacturer for use with Campbell Hausfeld air compressors. The dial reads 0-250 PSI. Please note this gauge has a durable metal body and it is sold individually. You should only need a wrench and a thread-sealing tape to complete this repair.

This is a genuine item that is supplied by the original equipment manufacturer for use with Campbell Hausfeld air compressors. The purpose of a pressure switch is to control when the compressor should start and stop building up pressure. Unfortunately, over time components will wear out and may begin to fail eventually requiring a replace...Read morement. This pressure switch cuts in at 120psi and cuts out at 150psi. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality pressure switch is sold individually.

This Power Cord and Plug Assembly is an OEM sourced part for air compressors. It is wired to the electric motor in order to provide power from a standard outlet. This part is black, consists of a metal wire in a rubber insulated cable, and is sold individually. Depending on how worn it is, your compressor may no longer get power or may ...Read morehave sparks coming from it when it needs to be replaced. If you notice any visible damage such as exposed wires, cracks, or frays, it should be replaced. You will need a screwdriver, pliers, and a wrench to complete this repair. Customers rate this repair as Easy.

Genuine Campbell Hausfeld replacement part, this item is sold individually. The ST033001AV Compression Nut is used to attach the copper tubing to certain components of the compressors listed below. Along with the Compression Nut you will need to use a compression sleeve ( or Ferrule) to seal the tube from leaking air. The Compression Nut will go on the tubing first then the Ferrule will slide into the nut.

This part is an OEM from the Campbell Hausfeld manufacturer. The pump/motor assembly is constructed of metal and plastic parts, and is designed for use with many oilless air compressor devices. This component is fitted onto the tank bracket. The purpose of this assembly is to fill tank with pressurized air. A wrench is needed in the repair. The pump/motor assembly is sold individually.

It is a genuine manufacturer-supplied item that is made for Campbell Hausfeld air compressors. O-rings are commonly utilized to provide an air-tight seal between connected components. Unfortunately, over time the material will wear out and it may begin to crack eventually requiring a replacement. Check the diagrams for your model to ensur...Read moree the correct repair procedure. A screwdriver and a wrench set might be needed to replace this inspection port o-ring.

This kit includes one metal tube and two rubber ferrules. The tube and ferrules connect to compression nuts on both sides of the tube. They are to be used in air compressors made by Campbell Hausfeld. A wrench may be needed to install these parts. These are authentic items supplied directly from the original equipment manufacturer.

This motor bracket is an original part from Campbell Hausfeld. The metal bracket is compatible with many air compressors. This item has been designed to secure the pump/motor assembly to the compressor tank. A wrench and a screwdriver are helpful in making the removal and repair. The motor bracket is sold individually.