WL660500 Husky Compressor - Overview

This Power Cord and Plug Assembly is an OEM sourced part for air compressors. It is wired to the electric motor in order to provide power from a standard outlet. This part is black, consists of a metal wire in a rubber insulated cable, and is sold individually. Depending on how worn it is, your compressor may no longer get power or may ...Read morehave sparks coming from it when it needs to be replaced. If you notice any visible damage such as exposed wires, cracks, or frays, it should be replaced. You will need a screwdriver, pliers, and a wrench to complete this repair. Customers rate this repair as Easy.

This motor bracket is an original part from Campbell Hausfeld. The metal bracket is compatible with many air compressors. This item has been designed to secure the pump/motor assembly to the compressor tank. A wrench and a screwdriver are helpful in making the removal and repair. The motor bracket is sold individually.

This part is an OEM from Campbell Hausfeld. The axle bolt is compatible with many air compressors, and is sold individually. The metal bolt fastens the wheel to the base of the tank, providing movement to the device. A wrench and pliers are needed for the removal and replacement.

This item is sold individually and is made of metal. The flat head mach screw attaches to the motor. This part may become stripped or broken and will need to be replaced. It is an OEM part sourced directly from the manufacturer and used in compressors and pumps made by Campbell Hausfeld. A torx screwdriver might be needed during the installation process.

It is a genuine replacement part that is supplied directly from the original equipment manufacturer, it is specially designed for use with Campbell Hausfeld air compressors. For the correct location and use of this hardware make sure to check appropriate diagrams of your model. Please note this high-quality screw is sold individually.

This is an authentic manufacturer-sourced component which is specially made for use with Campbell Hausfeld air compressors. The unloader tube is connected to the pressure switch to allow excess pressure to drain out. Unfortunately, over time it will wear out and it may begin to fail eventually requiring a replacement. Keep in mind this hi...Read moregh-quality item is made of durable material and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this part.

Authentic Campbell Hausfeld replacement part designed to work with air compressors. The pressure switch is made to tell your compressor when to stop and when to start building up pressure. There are multiple reasons a pressure switch could be leaking air. Replacing switch should keep it running at optimum performance. To complete replace...Read more this pressure switch you will need: wrench set, nut driver set and a thread-sealing tape. • Shut off the electricity and drain the air tank • Remove the tank pressure gauge • Remove the pressure switch tube • Remove the pressure regulator assembly • Disconnect the wires • Remove the safety valve • Install the new pressure switch • Reinstall the safety valve • Connect the wires • Reinstall the pressure switch tube • Screw the pressure gauge onto the new pressure switch and tighten the gauge firmly • Test the air compressor

The head attaches to the discharge valve gasket. This is a genuine Campbell Hausfeld part sourced directly from the manufacturer for use in compressors and pumps. It is made out of metal and is sold individually. When replacing this item a wrench might be required during the installation process. This part may become broken and will need to be replaced.