WL650001AJ Campbell Hausfeld Compressor - Overview

Designed for use in compressors, this genuine replacement part is used to provide a seal and prevent leaks. It is red, made of rubber, is not part of a kit or assembly, and is sold individually. When this part is worn, you will notice leaks from your machine, and it will need to be replaced. As with most rubber seals, this part is known...Read more to wear with regular use of your compressor, and will no longer be able to properly seal when it needs to be replaced. It is found at the bottom of the air tank, and you will need a wrench to complete this repair. Customers rate this repair as Easy.

This exhaust tube is a genuine item that is supplied directly from the original equipment manufacturer for Campbell Hausfeld air compressors. It is a high-quality replacement for a missing or damaged component that was installed on a new unit. This is the tube that connects to the check valve. A check valve is an important safety feature ...Read morethat will release excess pressure from the tank. Please make sure to check the appropriate diagrams of your model for the correct location and installation of this component. Keep in mind one durable metal exhaust tube and two ferrules are included.

This motor bracket is an original part from Campbell Hausfeld. The metal bracket is compatible with many air compressors. This item has been designed to secure the pump/motor assembly to the compressor tank. A wrench and a screwdriver are helpful in making the removal and repair. The motor bracket is sold individually.

It is an authentic manufacturer sourced replacement head gasket that is specially produced for Campbell Hausfeld air compressor pumps. The purpose of this gasket is to create an air-tight seal between the head and the cylinder case. Over time gaskets tend to get compressed and deteriorate eventually requiring replacement to maintain peak ...Read moreperformance. Please note this part is made from high quality composite material and it is sold individually.

This part is an OEM from Campbell Hausfeld. The axle bolt is compatible with many air compressors, and is sold individually. The metal bolt fastens the wheel to the base of the tank, providing movement to the device. A wrench and pliers are needed for the removal and replacement.

This is an authentic replacement part sourced directly from the manufacturer. The wheel is commonly found in Campbell Hausfeld air compressors. This part is made of high-quality plastic and rubber, and is placed on the sides of the tank to make the machine easier to relocate. You will require a wrench when replacing this item. The wheel is provided as an individual replacement part.

This item is sold individually and is made of metal. The flat head mach screw attaches to the motor. This part may become stripped or broken and will need to be replaced. It is an OEM part sourced directly from the manufacturer and used in compressors and pumps made by Campbell Hausfeld. A torx screwdriver might be needed during the installation process.

It is a genuine replacement part that is supplied directly from the original equipment manufacturer, it is specially designed for use with Campbell Hausfeld air compressors. For the correct location and use of this hardware make sure to check appropriate diagrams of your model. Please note this high-quality screw is sold individually.

Authentic Campbell Hausfeld replacement part designed to work with air compressors. The pressure switch is made to tell your compressor when to stop and when to start building up pressure. There are multiple reasons a pressure switch could be leaking air. Replacing switch should keep it running at optimum performance. To complete replace...Read more this pressure switch you will need: wrench set, nut driver set and a thread-sealing tape. • Shut off the electricity and drain the air tank • Remove the tank pressure gauge • Remove the pressure switch tube • Remove the pressure regulator assembly • Disconnect the wires • Remove the safety valve • Install the new pressure switch • Reinstall the safety valve • Connect the wires • Reinstall the pressure switch tube • Screw the pressure gauge onto the new pressure switch and tighten the gauge firmly • Test the air compressor