WL611100AJ Campbell Hausfeld Compressor - Overview

This replacement filter element is an authentic OEM item that is commonly utilized on Campbell Hausfeld air compressors. Its purpose is to filter out dust and debris from contaminating the engine with the air that goes into the carburetor. Please note this felt filter element is sold individually. Replacing it is a very simple task that does not require any tools.

It is an authentic manufacturer sourced replacement head gasket that is specially produced for Campbell Hausfeld air compressor pumps. The purpose of this gasket is to create an air-tight seal between the head and the cylinder case. Over time gaskets tend to get compressed and deteriorate eventually requiring replacement to maintain peak ...Read moreperformance. Please note this part is made from high quality composite material and it is sold individually.

This is an authentic OEM approved replacement part that is commonly utilized on Campbell Hausfeld air compressors. Its purpose is to ensure the air that goes into the unit is free of dust and other harmful contaminants. Over time the filter will get dirty and clogged restricting the air flow, inspect it periodically and replace filter as ...Read moreneeded to maintain peak performance. Please note this durable pleated paper filter is sold individually.

This is a manufacturer sourced replacement part designed for use with Campbell Hausfeld air compressors. The pressure switch tells your compressor when to stop and when to start. There are multiple reasons a pressure switch could be leaking air. If it is leaking air the pressure switch should be replaced for a compressor to operate proper...Read morely and safely. To complete this repair you would need: wrench set, nut driver set and a thread-sealing tape. • Shut off the electricity and drain the air tank • Remove the tank pressure gauge • Remove the pressure switch tube • Remove the pressure regulator assembly • Disconnect the wires • Remove the safety valve • Install the new pressure switch • Reinstall the safety valve • Connect the wires • Reinstall the pressure switch tube • Screw the pressure gauge onto the new pressure switch and tighten the gauge firmly • Test the air compressor

This is a genuine Campbell Hausfeld replacement part manufactured for use with air compressors. This special adapter is threaded to screw into the cylinder head on the pump, and connects the filter housing. This adapter requires two bolts to secure it to the filter housing, please note the adapter is sold individually.

This is the genuine OEM sourced replacement part that is specially designed for use with Campbell Hausfeld air compressor pumps. The purpose of this component is to provide an air-tight seal for the cylinder, over time it may wear out and begin to crack eventually requiring a replacement. Keep in mind this high-quality hardware is made of durable composite material and is sold individually.

This is an authentic Campbell Hausfeld replacement part manufactured for use with air compressors. The filter gasket is used to for a seal at the connection between the air filter and cylinder head. It is recommended to replace gaskets when servicing the air compressor to ensure proper seals when the parts are reassembled. This filter gasket is sold as an individual replacement part.

This replacement axial fan is an authentic item that is supplied directly from original equipment manufacturer for use with Campbell Hausfeld air compressors. It is the main fan which connects to the motor helping to cool the unit. This fan is made from durable plastic and it is sold individually, please note the hardware to secure this item is sold separately.

This is a genuine replacement part sourced from the original manufacturer for use with Campbell Hausfeld air compressors. The left-hand or reverse threaded screw is commonly used to secure the compressor's fan or blower assembly. This screw is available as an individual replacement part, please see model diagram for associative parts.