WL600700AJ Campbell Hausfeld Compressor - Overview

This pressure switch is supplied directly from original equipment manufacturer. It is a customer designed item made for use with Campbell Hausfeld air compressors. The purpose of a pressure switch it to control when your compressor should start or stop building up pressure. This kit includes: installation instructions, pressure switch, tw...Read moreo (2) gauges, regulator, safety valve, relief line and hardware. To complete this repair you would need a wrench set, nut driver set and a thread-sealing tape. • Shut off the electricity and drain the air tank • Remove the tank pressure gauge • Remove the pressure switch tube • Remove the pressure regulator assembly • Disconnect the wires • Remove the safety valve • Install the new pressure switch • Reassemble and test the air compressor

This replacement filter element is an authentic OEM item that is commonly utilized on Campbell Hausfeld air compressors. Its purpose is to filter out dust and debris from contaminating the engine with the air that goes into the carburetor. Please note this felt filter element is sold individually. Replacing it is a very simple task that does not require any tools.

It is an authentic manufacturer sourced replacement head gasket that is specially produced for Campbell Hausfeld air compressor pumps. The purpose of this gasket is to create an air-tight seal between the head and the cylinder case. Over time gaskets tend to get compressed and deteriorate eventually requiring replacement to maintain peak ...Read moreperformance. Please note this part is made from high quality composite material and it is sold individually.

This is an authentic OEM approved replacement part that is commonly utilized on Campbell Hausfeld air compressors. Its purpose is to ensure the air that goes into the unit is free of dust and other harmful contaminants. Over time the filter will get dirty and clogged restricting the air flow, inspect it periodically and replace filter as ...Read moreneeded to maintain peak performance. Please note this durable pleated paper filter is sold individually.

This part is an OEM from Campbell Hausfeld. The axle bolt is compatible with many air compressors, and is sold individually. The metal bolt fastens the wheel to the base of the tank, providing movement to the device. A wrench and pliers are needed for the removal and replacement.

This is an authentic replacement part sourced directly from the manufacturer. The wheel is commonly found in Campbell Hausfeld air compressors. This part is made of high-quality plastic and rubber, and is placed on the sides of the tank to make the machine easier to relocate. You will require a wrench when replacing this item. The wheel is provided as an individual replacement part.

This is a genuine Campbell Hausfeld replacement part manufactured for use with air compressors. This special adapter is threaded to screw into the cylinder head on the pump, and connects the filter housing. This adapter requires two bolts to secure it to the filter housing, please note the adapter is sold individually.

This is an authentic OEM sourced part which is specially designed for Campbell Hausfeld air compressors. It is an identical replacement for a missing or damaged exhaust tube that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality tube is made of durable metal and is sold individually.

This is an OEM part made for use on Campbell Hausfeld air compressors. This rubber foot attaches to the bottom of the tank. It does not need special tools to repair. Simply slide onto the tank's bar. It stabilizes positioning of the compressor while protecting surfaces below. Sold individually.