WL505813 Campbell Hausfeld Compressor - Overview

The purpose of a gauge is to register the pressure readings inside the tank. This replacement gauge is sourced directly from original equipment manufacturer for use with Campbell Hausfeld air compressors. The dial reads 0-250 PSI. Please note this gauge has a durable metal body and it is sold individually. You should only need a wrench and a thread-sealing tape to complete this repair.

This ASME safety valve is constructed of high-qualty metal, and is made for use with many air compressor models. Fastened to the manifold, the safety valve diminishes air pressure when the pump is not shut off at the proper setting. This important component is sold individually. A screwdriver, adjustable wrench and a pair of pliers are of...Read moreten necessary for the removal and replacement. Please refer to the specific manual for additional repair information.

This genuine OEM air compressor intake filter assembly is designed to protect the compressor pump by filtering dust and debris from incoming air. It features a durable plastic housing with a replaceable paper filter element and is suitable for both indoor and outdoor use. The assembly threads directly into the compressor intake and can be...Read more mounted vertically or horizontally, making replacement straightforward. Installing a clean, properly functioning intake filter helps maintain airflow, reduce wear on internal components, and support reliable compressor performance.

This is a genuine Campbell Hausfeld replacement drain valve, sold individually. When using an air compressor, moisture naturally condenses inside the tank. If this water is left sitting for too long, it can lead to internal rust and damage. The drain valve allows you to release this built-up moisture easily. It's especially important to d...Read morerain your tank after each use—particularly if you tend to leave air in the tank for extended periods. Regular draining helps extend the life of your compressor and maintain its performance. Be sure to open the valve regularly to prevent water buildup and potential tank corrosion.

1/4

The shoulder bolt attaches to the rubber bushing and the roll bar. This item is sold individually and is made of metal. This part is an OEM from Campbell Hausfeld and Husky for use in air compressors. When replacing this bolt a wrench will be needed. It may become broken or stripped and will need to be replaced.

This replacement pressure switch is specially made for use with Campbell Hausfeld air compressors. The purpose of a switch is to control when compressor stops and when it starts building up pressure. If your pressure switch developed leaks it should be replaced for compressor to operate as intended. This item is sold individually. Repla...Read morecing this pressure switch is a relatively easy task. You would need a wrench set, nut driver set and a thread-sealing tape to complete this repair. • Unplug the unit and drain the tank • Remove the pressure gauge • Remove the switch tube • Remove the pressure regulator assembly • Disconnect the wires • Remove the safety valve • Install the new pressure switch • Reassemble and test the air compressor