WHL-10-1 Walbro Engine - Overview

This is an authentic component which is supplied directly from the original equipment manufacturer for use with lawn and garden equipment. It is an identical replacement for a missing or a faulty welch plug that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and ap...Read moreplication of this hardware. Keep in mind this high-quality plug is made of durable metal and is sold individually.

This is an original Walbro replacement part manufactured for use with carburetors. The gasket forms a seal between the float bowl and carburetor body. Gaskets in carburetors can wear out over time from exposure to fuel. It is recommended to replace carburetor gaskets during servicing to ensure proper seals. This gasket is sold individually.

This choke friction spring is sourced from the original equipment manufacturer for use in carburetors. It is a small, coiled metal spring that helps to maintain the desired position of the choke by providing the right amount of tension. If the spring wears down, breaks, or is dislodged from its position, you will notice difficulties start...Read moreing the engine, rough idling, and lower power output. To remove the spring, use a pair of needle nose pliers to detach it from the choke lever/plate. Install the new friction choke spring, and ensure it is adequately tensioned to keep the choke in place. Move the choke lever to confirm that the plate opens and closes freely, before reassembling your equipment.

This is an original Walbro replacement part that has been sourced from the manufacturer to be used with small engine carburetors. The metal screws are flanged and used to secure the throttle and choke valves. The valve screw is available as an individual replacement part, please note four screws may be required.

This swivel assembly kit is an OEM replacement component used in small-engine carburetor linkages, typically as part of the throttle or fuel control mechanism. It allows smooth pivoting movement between connected parts, helping maintain consistent control operation and proper fuel or throttle response. Made from lightweight, durable mater...Read moreial, it is an ideal replacement when worn or loose linkage components cause sticking, poor movement, or inconsistent engine behavior.

This is an authentic part that is supplied by the original equipment manufacturer for use with Walbro carburetors that are commonly installed on lawn and garden equipment. The float is used with a needle valve to allow fuel into the carburetor chamber as the chamber is drained to a specific level. Unfortunately, over time components may w...Read moreear out and begin to fail eventually requiring a replacement. Keep in mind this high-quality float assembly is sold as an individual item.