This range hood slide switch is designed to control key functions such as fan speed or lighting through a smooth, easy-to-use sliding mechanism. Installed behind the control panel, it allows users to adjust ventilation or lighting settings precisely for optimal kitchen comfort and visibility. Built for durability and consistent performanc...Read moree, the switch is engineered to fit securely and operate reliably with regular use. Replacing a worn or malfunctioning slide switch can resolve issues such as unresponsive controls, inconsistent fan speeds, or lighting that will not turn on or off properly, helping restore normal range hood operation and dependable control.
This control slide switch allows users to manually adjust or activate specific appliance functions through a simple sliding motion. It provides reliable mechanical input to the control system and is often replaced when switching becomes inconsistent or unresponsive. Built for durability, it supports smooth operation and accurate control selection.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Old grease filters were coming apart due to two tiny lost screws which had popped out. Tried to replace them at ACE Hardware and found nothing that tiny! Therefore just ordered replacement grease fikterd.
4 of 5 peoplefound this instruction helpful.
Anneliese from Sarasota, FL
Very Easy
Less than 15 mins
The only poroblem I had was finding the Model number. I entered WWW….instead of WVW (my eyesight and error??.Receiving the new filters was prompt! THANK YOU!
Was this helpful?
Thank you for voting!
one switch went out on the range hood controlling the lights.
3 of 3 peoplefound this instruction helpful.
Jeffrey from MILTON, FL
Very Difficult
More than 2 hours
Screw drivers
The repair did not happen. Parts select sent me the wrong part. They sent a cover plate without any switches. I;m still waiting for the correct part.!!!!!!!!!!!!!!!!!!!!!!
Was this helpful?
Thank you for voting!
SWITCH CONTROL UNIT HAD BROKEN OFF FROM ONE END OF ITS INTERIOR MOUNTING
2 of 3 peoplefound this instruction helpful.
NICHOLAS & LEIGH from CHARLOTTE, NC
A Bit Difficult
1- 2 hours
Screw drivers
Removed and cleaned to overhead grease trap filters which required a sink full of detergent some wire wool pads and and much elbow grease. This is probably a service task that should be performed at least annually for hoods in frequent use. And be careful not to cut your fingers on some of the sharp interior edges.
With the g
... Read morerease filters removed it was then possible to access the switch unit from the inside of the hood. Used a small Phillips screwdriver to loosen and remove the two fastening screws and removed and replaces the whole unit.